Table of Contents
Advertisement
Zero Search
The zero search feature enables the VCR to quickly return to a
counter reading of 0:00:00 anywhere
on the tape. This is
especially
convenient
when you want to repeat a segment of the
tape several times.
1.
Go to the beginning
of the program
you wish to return to.
2.
Press INFO twice
to display timer counter on the TV screen.
3.
Press CLEAR to reset the counter to 0:00:00.
4.
Continue
playing
the tape.
5.
Press STOP.
6.
Press SEARCH on the remote twice
to display the ZERO
SEARCH menu.
7.
Press REV to return to 0:00:00 on the tape.
ZERO
SEARCH
Current
tape
counter
is
2:17:25
Press
REV
to
go
to
0:00:00
Press
SEARCH
to
exit
ZERO
SEARCH
Searching
for
0:00:00
Press
STOP
to
cancel
Time
Counter
The time counter shows the actual time it takes to record a program
or play back a segment
of a recorded
tape. It helps locate the
beginning
or end of programs
you taped. The time counter resets to
0:00:00 whenever
the tape is ejected from the VCR.
For example,
if you record a 30-minute
program
at the beginning
of
the tape and you want to go to the end of that program
to begin
another
recording,
you would:
1.
Press INFO twice
to display the time counter.
2.
Press CLEAR to reset the time counter to 0:00:00.
3.
Press FWD to forward
the tape until the time counter reads
0:30:00.
.
.
Press STOP. This is the approximate
end of the program.
(You
may want to press PLAY to verify.) Now, you can begin
recording
at this spot.
Press INFO to remove the time counter from the screen and
return to the normal
display mode.
Hours
Minutes
0:30:00
!
Se_nds
28
Advertisement
Table of Contents
