Table of Contents
Advertisement
Using the PIP Feature
While you may use PIP in different ways, this basic PIP scenario
should get you started. While watching the TV, follow these steps
to use your VCR to supply the picture for PIP.
°
Press the PIP button on the remote.
The PIP window
appears
on the screen. Notice the channel marker at the bottom
of
the screen displays the current PIP channel, not the main
picture channel.
2.
Turn on the VCR and tune the PIP channel to receive the VCR
signal (Video1 or Video2).
°
Tip: You can turn the VCR on and tune to the VCR channel
with the press of a button.
For example, if you program
the
Autotune
feature,
you can tune to the Video1 input channel
when you press the VCR1 button
on the remote. In PIP mode,
pressing the VCR1 button tunes the PIP windowto
the
Video1 input channel.
Use the channel up and down buttons
and the other PIP
buttons,
MOVE, SWAP and CH CTRL to adjust the two
pictures.
PIP Problems?
Make sure the remote is in the right mode.
For example,
once you turn on the VCR with the VCR1 button,
you can't
SWAP the pictures until you put the remote in TV mode. Just
press the TV button.
No signal or bad reception?
Most VCRs and satellite
receivers
have an antenna
or TV button.
If your cable or off-air
antenna
goes into your VCR or satellite
receiver, then into
your TV, try pressing the antenna
or TV button on the front
of the component.
Tip: If programmed
to control your VCR, the ANTENNA
button on the remote acts as a TVNCR button.
Check the connections.
PIP requires a second video source,
like a VCR or satellite receiver, connected
to your TV with
audio/video
cables. If you use a cable box, you may need
extra equipment.
Contact your cable company for more
information.
"
o
CABLE OR ANTENNA
VCR 1
To see a different picture in the PIP
window, you must connect another
video source, like a VCR. This
connection also requires audio/video
cables.
51
Advertisement
Table of Contents
