Table of Contents
Advertisement
Connections
&
Setup
_i_!:i
_i
ii_•,, ¸
Step 3: Configuring
for a VCR
1.
If your TV is connected
to a VCR. press OK.
If it is not, highlight No and press OK (a screen appears
reminding you to
connect your G-LINK cable to your TV and VCR).
2.
Use the up and down arrow huttons to highlight the brand of your VCR that
p._,_,_
is connected
to the TV.
If your brand isn't listed, highlight Not Ltsted and press OK.
.
Tune your VCR to channel 02. Next, turn OFF your VCR. When you
complete
these steps, press OK to begin testing.
Important
Note: When code testing is in progress, don't touch
our T_,
Y
VCR, or any of the remote controls for these products.
4.
Look at the front display of your VCR. If your VCR turned on automatically
and changed
to channel 09, the test was successful.
Highlight
Yes and press
OK.
If your VCR didn't change to channel 09, you can either choose No or Test
this code again.
If you think your TV or remotes might have been touched
during the test,
tune your VCR to channel 02, turn off your VCR and highlight
Test this
code again.
If you don't think the test was interrupted,
highlight
No. Tune your VCR to
channel 02 and turn off your VCR. Press OK (the GUIDE Plus+ system starts
testing another set of codes.)
Keep following the previous instructions
until the VCR finds the correct
code.
18
Chapter
1
Hide quick links:
Advertisement
Table of Contents
