Table of Contents
Advertisement
Turns
off while
playing
You may have scheduled
the TV to turn off via the Schedule
function.
Electronic
protection
circuit may have been activated because of
a power surge.
Wait 30 seconds and then turn on again.
If this
happens frequently,
the voltage in your house may be
abnormally
high or low.
Blank
screen
Maybe the component
connected
to the input jacks is not
turned
on.
Try another
channel.
Maybe you have set Parental
Controls
to block the channel.
Turn off the TV. Wait five minutes.
Turn on again.
No sound,
picture
okay
Maybe sound
is muted.
Try pressing
volume
up button
to
restore
sound.
Maybe speakers are turned
off. Check the Audio Output and
Speakers control
panel in the Audio menu.
If using an S-VHS component,
remember
to also connect the
component's
L and R AUDIO OUT jacks to the TV's L and R
IN PUT jacks.
Can't
select
certain
channel
The channel
may be blocked or not approved
in the Parental
Controls
menu.
If using a VCR, check to make sure the TV/VCR button on the
VCR is in the correct "mode."
Noisy
stereo
reception
May be a weak station.
Use SOUND button to change to mono
mode instead of stereo.
No picture,
no sound
but
TV
is on
If watching
VCR (connected
only through
antenna
input), make
sure TV is tuned to channel 3 or 4 - same as CH3/4 switch on
VCR. Also check to make sure the TV/VCR button on the VCR is
in the correct "mode."
5O
Advertisement
Table of Contents
