ProForm CROSSWALK si User Manual page 13

5. SYMPTOM: THE DISPLAYS OF THE CONSOLE: DO NOT FUNCTION PROPERLY
a. The console requires three "AA" batteries (not
included); alkaline batteries are recommended. If
the displays of the console do not function prop-
erly, the batteries should be replaced. Open the
battery cover as shown at the dghL Press three
batteries into the battery compartment, with the
negative (-) ends of the batteries touching the
springs. Close the battery cover.
.Cover
6. SYMPTOM: ONE OF THE UPPER BODY ARMS SQUEAKS DURING USE
a. Correcting this problem requires a small amoun! of white marine
grease, available at most department stores.
Turn the Resistance Knob (101) counterclockwise until it can be
removed. Remove the Resistance Cone (100) and the Upper
Body Arm (102), along with the Resistance Washers (108),
Spring Washer (111), Thrust Washers (109), and Thrust Bearing
(110). (Note: If the Resistance Sleeve [99] comes out of the
Resistance Bracket [97], press it back in.) Apply a thin layer of
white marine grease to the outer surface of the Resistance Cone
(100). Reattach ell parts in the order shown at the right.
97
13