ProForm XP 590S User Manual page 7

5, Set the ConsoUe Base (101) on the Uprights (97), Thread
the four Upright BoUts(76) with four UnternaU Star
Washers (77) into the Uprights and the ConsoUe Base,
Be careful not to pinch the Wires (not shown) in the
Uprights. Tighten the two Upright BoUtsindicated by the
arrows first; then, tighten the remaining two Upright
BoUts,
Make sure that the Left and Right Trays (109, 111 ) are
pressed into the Console Base (101),
101
76
6, Fold the treadmill to the storage position (see page 21),
if the Wheels (94) are resting on the floor, or if the tread°
mill rocks slightly, turn one or both of the Leveling Feet
(95) under the Uprights (97) until the Wheels are off the
floor and the rocking motion is eliminated, Note: if neces-
sary, tip the treadmill and use a phillips screwdriver to
turn the Leveling Feet,
94
94
7, Make sure that all parts are properly tightened before you use the treadmi& Note: Extra hardware may
be included, Keep the included allen wrenches in a secure pUace,The Uargeallen wrench is used to adjust the
waUking beUt(see page 23), To protect the floor or carpet, pUacea mat under the treadmill Ufthere are thin
sheets of cUear pUastic on the decaUs, remove them,
If you purchase the optional chest pulse sensor (see
page 20}, follow the steps below to install the receiver
included with the chest pulse sensor.
1, Make sure that the power cord is unplugged. Remove
the indicated Screw (108) and the Access Door (116),
2, Remove the paper from the adhesive pad on the back of
the receiver (A), Hold the receiver so the small cylin_
tier is near the tower edge of the receiver and facing
the ConsoJe (107} as shown. Firmly press the Receiver
onto the indicated corner of the Access Door (116),
Connect the wire on the receiver to the indicated wire exo
tending from the Console,
3, Make sure that no wires are pinched. Reattach the
Access Door (116) with the Screw (108), The wires ino
duded with the receiver may be discarded,
107
Wire
\
7