Advertisement
Your stand comes mostly assembled.
All you need to do is insert the shelf into the stand and attach the glass
door.
As you can see from the following instructions,
completing your stand is a easy as (steps) one, two, three...
S t
_..._1.
Insert
the shelf in the stand
• Place the 4 shelf support pins (F) into the pre-drilled
holes
inside the stand at your desired
shelf height.
• Put the shelf(G)
on the pins.
Attach the glass door
• Insert a bushing (A) into the hole in the inside bottom of
the sland. Place the pin of the bottom
hinge (D) into this
bushi!ng (A).
• Peel the paper backing
from the 2 hinge plates
(C) and press
them on the inside of the glass door (H). Stick one along the
top, ,'md the other along the bottom.
• Slip _:he top hinge (B) over its hinge plate (C). (Make sure the
hinge, plate is under the hinge's
screw holes.) Use 2 screws (N)
to secure the top hinge to the door. Do not overtighten
the
screws.
• Now, slide the bottom hinge (D) over its hinge plate (C).*
(Make sure the hinge plate is under the hinge's
screw holes.)
Use 2 screws (N) to secure the top hinge to the door. Do not
overtighten
the screws.
• Insm* a bushing
(A) into the hole on the inside top of the stand.
Slide the glass door (H) into position
on the stand by inserting
the pin of the top hinge into this bushing
(A). The bottom edge
of the glass should slide into the bottom hinge (D).
• Carefully
close the door and inspect it. If necessary,
you can
adjust the position of the glass door. Simply loosen the hinge
screws (N) slightly,
slide the door into the desired
position
in
the hinges,
and retighten
the screws.
• Remove
the paper backing
from the touch plate's foam pad (E)
and place the pad over the top of the glass door. Position
the
pad so it aligns with the touch latch. Then, press the touch
plate (E) over the pad.
* Because
glass door sizes may differ slightly,
two plastic
washers
(O) are provided
to raise the bottom
hinge (D) and
keep it from rubbing
against the stand base. Place the
washer(s)
(O) under the bottom hinge (D) as shown in the
illustration
below.
Install the washer(s)
(0) only if needed.
0
0
0
Advertisement
