RCA PS27108 Connection Manual page 27

Trouble Checks
Trouble
VCR ((onfiatued)
Can't record one channel
with the VCR while
watching a different channel
on the TV
Checks and Adjustments
For connections 4B. 5B:
1. Turn on TV, VCR, satellite receiver, and cable box (if required).
2. Make sure IRD[I'V switch on satellite receiver is in "IV position so signal
from cable box or antenna is coming out the OUT TO "IVjack on the
satellite receiver.
3. If cable box is required, use CHANNEL buttons on VCR to tune VCR to
output channel of cable box (usually 02, 03, or 04).
4. Select channel 03 or 04 on TV (depending on the position of the
CH3/CH4 switch on the back of the VCR).
5. Select desired channel with CHANNEL buttons on cable box if cable box
is required. If cable box is not required, select desired channel with
CHANNEL buttons on VCR.
6. Insert tape in VCR and press RECORD on VCR.
7. To watch satellite channel, select channel 00 on TV.
8. Then select desired channel to watch with CHANNEL buttons on
satellite receiver.
For connections 4Co 5C:
1. Turn on TV and select channel 00 on TV with remote.
2. Turn on satellite receiver and select desired satellite channel with
CHANNEL buttons on satellite receiver.
3. Turn on VCR and set it to line mode (see glossary) so you can see the
satellite signal coming into its AUDIONIDEO IN jacks.
4. Insert tape in VCR and press RECORD on VCR.
5. PressTVNCR button on VCR. This lets the cable signal flow directly
out of the OUT TO TV jack of the VCR without affecting the recording.
6. If cable box is required, turn on cable box, change channel on TV to
output channel of cable box (usually 02, 03, or 04), and select desired
channel with CHANNEL buttons on cable box.
7. If cable box is not required, select desired channel with CHANNEL
buttons on TV.
continued on the next page 25