Mitsubishi WS-73907 Owner's Manual page 20

Part I1: Installation
(Figure 1)
The TV back panel has 5 RCA-type connec-
tors, for the DTV connection. The back
panel of your DTV receiver may use RCA-
type connectors or BNC-type connectors. If
your DTV receiver comes with BNC type
connections, you will need to purchase BNC
to RCA adaptors to connect the TV to the
DTV receiver. These adaptors should be
available at most electronic supply stores.
BNC to A or
RCA BNC Fitted to
Adaptor Connector Connection
or
Figure 1. DTV connectors and adaptors.
RCA
Connector
DTV Receiver with Component
Video Connections
(Figure 2)
[] Connect the outside antenna, cable, or
satellite to ANT, or SATELLITE IN on the
DTV receiver (see your DTV receiver's
owner's guide for instructions, and cable
compatibility).
[] Connect the incoming terrestrial antenna,
or cable (not satellite) to ANT-A on the
TV back panel (a coaxial splitter, avail-
able at most electronic supply stores,
may be required to complete this instal-
lation).
[] Connect the RCA-type cables from the
Y/Pr/Pb outputs on the DTV receiver to
HIGH RESOLUTION INPUT Y/Pr/Pb on
the TV back panel. You may need to set
the DTV input assignment to YPrPb in
the Assign Input menu, page 33.
[] Connect the L (left) and R (right) audio
cables from the DTV receiver to DTV
AUDIO on the TV back panel.
[] To utilize the benefits of a digital A/V
receiver, connect your DTV receiver's
digital audio out to a digital input on your
digital A/V receiver.
_¸¸¸i¸ i_! i _3!J!i_!!iii
P4_ ¸¸¸17r_ _i :_ _i_!i
4_ _" or Ca_e _n°3m_ng Antenna_
,91 J
Figure 2. Connecting the DTV receiver with component
video connections.