Mitsubishi WS-73907 Owner's Manual page 13

Part I1: Installation
Back Panel
®®®®
® ®®®®®
® ®®®®®
ER EMITTER HOME THEATER
®®®4
[] STB (Set-Top-Box)
This input can be used for the connection of any device with an S-Video output.
[] Inputs
1-3
These inputs can be used for the connection of a VCR, Super VHS (S-VHS) VCR, laser
disc player, or other A/V device to the TV. Please note that if you connect to the S-VIDEO
terminal, the VIDEO terminal is deactivated. The VIDEO terminal is active when there is
no S-Video connection.
[] Output (Monitor and PIP)
The Monitor Output sends the TV audio and video signals, excluding component video,
VGA, or DTV video, to an A/V receiver or other equipment. The PIP output sends the
PIP's or POP's audio signal to an amplifier or wireless headphones. If no PIP or POP is
displayed, the PIP output will send the main picture audio signal.
[] Antenna (ANT-A, LOOP OUT, and ANT-B)
ANT-A and ANT-B receive signals from VHF/UHF antennas or a cable system. LOOP OUT
sends the ANT-A signal out to another component, such as a cable box or VCR.
[] IR Emitter Home Theater (System 4 Home Theater IR Control)
Connecting IR emitters here allow the TV to automatically change a digital A/V receiver's
input in a home theater setup, and pass IR commands to other A/V devices.
[] VGA
This input can be used for the connection of a computer. Please see Appendix B, page
61, for signal compatibility.
[] Component Inputs 1-2
These inputs can be used for the connection of A/V equipment with component video
outputs, such as a DVD player. Please see Appendix B, page 61, for signal compatibility.
[] DTV Input
This input is used to connect a DTV receiver, and can be configured for HDTV component,
RGB sync on green, and RGB plus H&V. Please see Appendix B, page 61, for signal
compatibility.