Using The Battery Pack - Mintek MDP-1760 Manual

Attach the batte
U pack properly following the explanation below. Make sure that the battery pack is
attached firmly to the player when using it. Otherwise, the battery may become detached and cause
person injury.
Charge it before using.
• ATTACHING THE BATTERY PACK
First disconnect the AC adaptor and the power cord from the player, then attach the battery pack.
1. Turn the player off.
2. Turn the player upside down.
3. Insert the battery pack's catches into the player's corresponding holes. Then, slide the battery pack until
it is attached firmly.
Note: Remove the battery pack fiom the player after being used.
• CHARGING THE BATTERY PACK
1. Turn the player off. The battery pack will charge only when the POWER to the player is turned OFF.
2. Attach the battery pack to the player.
3. Connect the supplied AC adaptor and the power cord to the player. Charging starts, and the
POWER/CHG indicator illuminates orange. When the charging is completed, the indicator turns off:
Notes:
1) While the charge is in progress, do not disconnect the AC adaptor and the power cord until the
POWEPJCHG indicator turns off: The charging time of a battery pack is approximately 4.5 hours and
depends on environmental conditions.
2) The attached battery pack may get warm when you are charging it or operating the player. This is not a defect.
3) The battery indicator is shown on the screen when the power in the battery pack is running low.
• DETACHING THE BATTERY PACK
1. Turn the player off:
2. Disconnect the AC adaptor and the power cord from the player.
3. Turn the player upside down.
4. Slide the battery pack's lock switch in the open direction, then slide the player in the correct direction
to remove it.
• PLAYBACK TIME
Generally, after the battery pack is recharged,its continuously working time is as fbllows. For
example:
Model Operating status Continuous playing time
MDP-1760 Play DVD, TFT on about 2.5 hours
Play DVD, TFT off about 4 hours
• CONDITIONS AND ATTENTION
While using the battery pack, the environmental temperature should be 5C (41 F) to 35C (95'F).
A newly purchased battery pack can only be used after being charged.
To undertake the longest service lil_ of the battery pack, charge it under or close to indoor-temperature.
Never dispose of in fire, water or heat up.
Do not use in high temperature or near heat sources.
Never connect the positive and negative poles with metal.
Do not open the battery, refer servicing only to qualified service personnel.
.36.