Controls And Cycle Status - Maytag MDB7749SAM0 User Instructions

OPTION SELECTIONS
OPTIONS dish load types
DESCRIPTIONS USE WITH: ADDED
TIME TO
CYCLE
Increases the target Water Jet Clean Plus Steam, Normal,' 10 min,
" I temperature during the wash portions and Auto Clean
I
hi temp
)wa,h of the cyclel Adds heat, time, and
' water. I I
All loads
[]
heated
dry
All loads
2 4 8
___
delay
hours
Use for best drying results in Jet Clean Plus Steam, Normal, 45 min.
combination with rinse aid. Turn off Light, Quick Wash and Auto Clean
when loads contain plastic
dinnerware that may be sensitive to
higher temperatures.
Use for best drying results in Jet Clean Plus Steam, Normal, I 90 min.
combination with rinse aid. Turn off Light Quick Wash and Auto Clean I
when loads contain plastic I
d nnerware that may be suns t ve to
higher temperatures. _
Raises the water temperature inothe I Jet Clean Plus Steam, Normal, I 30 min.
final rinse to approximately 154 F I and Auto Clean I
(68 C). This high temperature rinse
sanitizes your dishes and glassware
in accordance with NSF/ANSI I I
Standard 184 for Residential I I
Dishwashers. Certified residential
dishwashers are not intended for
licensed food establishments.The I
San t ze opt on adds heat and t me to
the cycle. _
Delays the start of a cycle up to All cycles 2, 4, 8
8 hours, hours
All loads When Control Lock is lit, all buttons
are disabled. If you press any pad
while your dishwasher is locked, the
light flashes. The door can be opened
while the controls are locked.
CONTROL PURPOSE COMMENTS
To start or resume a If the door is opened during a CYcle or the power is interrupted, the START/RESUME
[] wash cyc!e indicator flashes. The cycle w II not resume unt I the door is closed and START/RESUME is
pressed.
NOTE: If the START/RESUME button iS located on top of doorl puSh door firmly clOSed
Within 3 seconds of pressing START/RESUME. If the door is not closed within 3 seconds,
the start button LED wil! flash, an audible tone wi!! be heard, and the cycle wi!! not start,
[]
Icancet I
To reset any cycle or
options during
selection.
To cancel a wash
cycle after it's
started.
Press CANCEL/DRAIN to reset any control selections made.
See "Canceling A Cycle" and "Changing a Cycle After Dishwasher Is Started" sections.
To tuin the audible Press and h01d theHi Temp Wash button for 3 seconds to turn the audible tones on oroff_
[] tones on croft. Only audible tones for confirming button presses can be turned on/off, Important audible
temp
tones, such as indicating a cYCle has been interrupted, cannot be deactivated.