Pentax Optio WG-1 GPS Operating Manual page 73

Message i Description
Displayed when you try to switch to _ mode while an
Data being recorded image is still being recorded, or when the protect setting or
DPOF setting is being changed. It disappears after the
image is recorded or the setting is changed.
Displayed when the camera takes more than five seconds
Data being processed to display an image due to image processing, or when the
SD Memory Card or the built-in memory is being formatted.
Built-in memory full Displayed if the built-in memory is full when saving a file.
No image to be Displayed when there are no images or sound files.
processed
This image/sound Displayed for files that cannot be processed.
cannot be processed
Displayed if no SD Memory Card is inserted when "image/
No card in the camera Sound Copy" is selected from the Playback Mode Palette
and the OK button is pressed.
The built-in memory is Displayed when there is insufficient built-in memory to
not enough to copy
images/sounds perform copying.
Cannot process Displayed when Red-eye Compensation processing fails.
correctly
Not enough battery Displayed when the battery is too low during Pixel Mapping.
power remaining to Change the battery (p.39) or use the AC adapter kit
activate Pixel Mapping K-ACl 17 (optional) (p.43).
No more images can be Displayed when you select more than the maximum
selected number of images.
The camera will turn off
to prevent damage from Appears when the temperature inside the camera exceeds
overheating the highest limit.
No more logs can be Displayed when there is no capacity to save a log in the
recorded, card, or there is a log with the 999 serial number. (Optio
Delete the record? WG-1 GPS only)