Table of Contents
Advertisement
Before requesting service for this unit, check the chart below for
a possible cause of the problem you are experiencing.
Some sim-
ple checks or a minor adjustment
on your part may eliminate the
problem and restore proper operation.
If you are in doubt about some of the check
points, or if the
remedies indicated
in the chart do not solve the problem, refer to
the directory
of authorized
service
centers (enclosed
with this
unit) to locate
a convenient
service
center,
or consult
your
Technics dealer for instructions.
(In U.S.A. consult
MSC Authorized
Servicenters
for detailed
in-
structions.)
I
Problem
Probable cause(s)
I
Suggested remedy
I
Changer will not play.
The disc in the changer
does not play.
Play stops before changing
to the next disc.
A certain music
passage
can't be played correctly.
There Is noise from the
tuner or disturbance
on the
TV screen.
When program
play is
started,
an error message
(- E) appears on the
display.
An error message (- E)
appears on the display, and
the changer stops
operating.
The loading drawer stops In
the middle
of opening.
A disc(s) or other foreign object(s) has fallen
inside the changer.
Moisture has collected
in the changer.
The disc is upside down.
The disc is dirty.
The disc is scratched.
The disc is warped.
The disc is not within specified
standards.
The loading drawer is open.
The disc is dirty.
The disc is scratched.
Caused by high-frequency
signals from this
changer.
Play was started without a track being
programmed.
The mechanism
of the changer has been
improperly
adjusted.
• Open the loading drawer, and then remove the
object.
• Switch on and allow the changer to dry out for about
one hour before using it.
• Make sure the label is facing upward.
• Wipe the disc with a soft cloth.
• Replace the disc with a new one.
• Press the OPENICLOSE button to close the loading
drawer.
• Wipe the disc with a soft cloth.
• Replace the disc with a new one.
• Use the changer further away from the tuner or TV.
• If the tuner or TV's antenna is the indoor type, use an
outdoor one.
• Program a track.
• Turn the unit off and then back on again.
However,
if the loading drawer is fully open, take out
the compact
disc(s) at the front position and then turn
the unit off and then back on again.
Product
service
Do not attempt
to remove the cover(s)
or repair the unit
yourself.
Refer servicing
to qualified personnel
only.
Product
information
For product service, product information
or assistance
in pro-
duct operation,
refer to the servicenter
directory.
19
Hide quick links:
Advertisement
Table of Contents
