Panasonic PT-53TWD63 Operating Instructions Manual page 29

Convergence (cont.)
Note: Convergence seldom needs adjusting except after
moving the PTV or to make minor adjustments.
Procedure
Press OK to enter convergence sub-meee field.
Press Cl-I • or CH • to select:
CONVERGENCE ADJ.- Select to correct minor
convergence problem.
Note: ARer selecting, press OK to continue
CONVERGENCE ADJ.
RESET TO DEFAULT - Select to set convergence
to factory default setting.
Note: After selecting, press OK to activate RESET
TO DEFAULT feature,
CONVERGENCE ADJ.
Procedure
After pressing OK the align Green to Center screen will
be displayed.
Then use the navigation buttons on the remote control
to align the horizontal and vertical green lines on screen,
with the cabinet reference marks on top center and left
center of cabinet, as shown below.
Reference Marks
Front of cabinet
,It
Press CH And VOL Key TO
A_ign Green Lines To The
• Center Mark On The Cabinet
Left _1 • Right
Down
Press Ok To Continue
Press OK button to display red center correction screen.
Note:
Use the navigation buttons on the remote control to align
the red cross with the white cross pattern at the center of
the screen.
Note: To prevent picture tube damage do not leave
test pattem on for an extended pedod of time.
Then press "0" on the remote control keypad to display
the BLUE center correction screen, repeat procedure for
adjusting blue. tf needed press "0" again to return to
RED correction screen.
An adjusted cross pattern appears white with a minimum
of color protrusion.
If Re_ Is P_o_u_ing From
Cen_e_C_oSS _e_s CH Ar,d
VOL _ey ToCorrec_
Lef[ _ • Rlgh[
DOWn
PRESS0 ToA_justBIde
pre_sokro_l_e
Press
_O _
_ BLUeFSP_o_rud_ngF_om
Ceq_et C_C_s #_es_ CH A_t}
VOL Key _ COf_e_
Le_t • _ R_ht
De_.n
9££SS 0 ToAdjust Re_
_ress Ok TO Con_r_e
MENU OPERA TIONS
NINE POINT CONVERGENCE CORRECTION
Note: Remote Control must be in TV mode,
Procedure
Press OK button to display red correction screen.
Press the 1 through 9 keypad buttons on the remote
control to select the desired convergence position,
Use the navigation buttons to align the RED cross with
the white cross pattern.
Note: An adjusted cress pattern appears white with a minimum
of color protrusion.
Press "0" on the remote control keypad to display the
BLUE correction screen, then repeat procedure.
To exit convergence screen press OK button, then press
EXIT to quit all menus.
Cable Module Info
This menu is used to provide information when a DCM
(Digital Cable Module) is inserted into the DCM
INTERFACE (POD INTERFACE) slot on the back of the
projection television. If no DCM is present and you try to
access the Cable Module Info, the message 'Cable Module
Not present' will be displayed on screen. To receive the
features offered by your cable company, you may have to
subscribe to those services.
Note:
Please contact your cable company regarding availability
of the DCM (Digital Cable Module). The cable module is
needed to receive premium digital services (where
available) through the cable input. You may also able to
order call-ahead pay per view events.
27 •