Manual Memory Presetting; Automatic Scanning; To Preset Am Stations In Monaural Position; About The Frequency Step - Technics SC-CH717 Operating Instructions Manual

Manual memory presetting
This feature allows you to manually preset stations into any desired
channel•
o_ -_:
1
3.5
2
4
This example shows how to memorize FM 88.1 MHz into preset
channel 1.
_ Press TUNER/BAND to select
FM or AM.
Each time you press TUNER/BAND,
"FM", "AM" will appear in order.
2 Press • or • to tune in to the
desired broadcast.
_LUME MULTi CONTROL I
• _- TUN*NG
l
3
Press SET momentarily.
Illuminates. Flashes,
,,; :??:2
".-'"°° o,-, , *%
-- , |, ----PRESET
Press <1 or • to select the de-
sired preset channel.
Flashes.
"": I
...............
,,,.Eo f--/ I'--/ t .s._c_ 4 i____ p.Ese,
Illuminates.
%
Press SET momentarily.
MEMO indicator will go out.
Automatic scanning:
Press and hold • or • until the displayed frequency begins to
change.
eThe changing of the displayed frequency will automatically stop if a
broadcast station frequency is located during the tuning process.
eWhen there is excessive interference, the automatic scanning may
not function.
To cancel the automatic scanning, press • or • once again.
To preset FM stations in monaural position:
1. Select the desired frequency.
2. Press FM MODE on the remote control to show "MONO".
3. Follow the procedure 3-5 on the left.
About the frequency step:
Each time you press • or •, the frequency display will change as
follows:
FM: 0.1 MHz step
AM: 10 kHz or 9 kHz step
(To change the AM allocation, see page 25.)
18