Table of Contents
Advertisement
ENSURING
PROPER
AIR CIRCULATION
In order to ensure proper temperatures, air must flow
between the refrigerator and freezer sections. As shown
in the illustration below, air enters at top of the freezer and
circulates down. From the bottom of the freezer, air is
forced up to the top of the refrigerator. Air enters
refrigerator through the top vent, then circulates and
exists at the bottom, where it returns to the freezer.
MULTI-FLOW
• Multi-Flow means powerful and effective cooling
operation. This is especially noticeable when new food is
placed in the refrigerator compartment.
• If water or foreign substances enter the cool air vent
while cleaning, efficiency will be lowered. In addition, if
gasket is damaged, efficiency may be lowered because
of escaping cool air.
SETTING
THE CONTROLS
• Your refrigerator has two controls that let you regulate
the temperature in the freezer and refrigerator
compartments.
• Initially set the REFRIGERATOR
CONTROL at 37°F
(3°C) and the FREEZER CONTROL at 0°F (-18°C).
Leave it at this setting for 24 hours (one day) to stabilize.
Then adjust the compartment temperature as desired.
• Refrigerator control: 33°F to 46°F (0°0 to 8°0)
The lower the number setting, the colder the refrigerator
compartment will become.
37 OFIS RECOMMENDED
ICE PLUS
• Freezer control: -6°F to 8°F (-21°C to -13°C)
When the setting is at a lower number, the freezer
compartment becomes colder. But the refrigerator
compartment becomes warmer because less cold air
flows into the refrigerator.
• ICE PLUS:
Press the ICE PLUS key and the LED will turn on. This
function will remain activated for 24 hours and intensify
the cooling speed of freezer and increase the amount of
ice.
ICE PLUS
0°FISRECOMMENDED
NOTE: If you want to change °F to °C, press and hold
COLDER key of freezer and COLDER key of refrigerator
over 5 seconds at the same time. and if you want to
change °C to °F, hold them for 5 seconds again.
Do not block any of cool air vents with food packages.
If the vents are blocked, airflow will be interrupted and
temperature and moisture problems may occur.
IMPORTANT:
Because air circulates between both
sections, any odors formed in one section will transfer to
the other. You must thoroughly clean both sections to
eliminate odors. To prevent odor transfer and drying out of
food, wrap or cover foods tightly. (See the Food Storage
Guide section for details.)
[_:i, CAUTION l
Display mode setting and its cancellation
• To enter this mode, raise either the Refrigerator or
Freezer temperature to its highest setting. Then, press
and hold WARMER Key for 5 seconds.
• Perform the same way again to cancel the display mode.
2O
Advertisement
Table of Contents
