MTD 11B-084E031 Operator's Manual page 10

Table of Contents

Advertisement

Available languages

Available languages

2.
If satisfied with the height of the handle, tighten the star
knobs atthe ends of the lower handle shown in Fig. 3-3.
For convenience of operation, you may adjust the handle
height as follows:
3.
Position the recoil starter
by following
the steps below:
a.
Hold the blade control against
the upper handle.
b.
Slowly pull the starter rope out of the engine. See
Fig. 3-4.
Figure
3-3
NOTE: Each end of the lower handle must be placed
in the
same position
on the mounting
brackets.
a.
Remove the star knobs shown in Fig. 3-3 and remove
the lower handle.
b.
Position each handle bracket stud into the top hole
in the lower handle.
c.
Tighten
the star knobs.
Figure 3-4
c.
Slip the starter rope into the rope guide.
d.
Tighten
the rope guide wing nut.
4.
Use the cable tie provided
to secure cable to the lower
handle. Pull the cable tie tight and trim excess. See Fig. 3-5.
L
J
Figure 3-5
,°I
SECTION3 -- ASSEMBLY & SET-UP

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

11a-084r22911a-084d000Series 080

Table of Contents