Troubleshooting; Built-In Diagnostics - Dell S2230MX User Manual

User's guide

Hide thumbs Also See for S2230MX:

Dimensional drawing (2 pages)

Setup manual (2 pages)

Setting up (2 pages)

Table Of Contents

Table of Contents

Back to Contents Page

Troubleshooting

Dell™ S2230MX/S2330MX monitor

Self-Test

Built-in Diagnostics

In-Store Demo

Common Problems

Product Specific Problems

WARNING:

Before you begin any of the procedures in this section, follow the

Self-Test

Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly

connected but the monitor screen remains dark, run the monitor self-test by performing the following steps:

1. Turn off both your computer and the monitor.

2. Unplug the video cable from the back of the computer. To ensure proper Self-Test operation, remove both Digital (white connector) and the Analog (blue

connector) cables from the back of computer.

3. Turn on the monitor.

The floating dialog box should appear on-screen (against a black background) if the monitor cannot sense a video signal and is working correctly.

While in self-test mode, the power LED remains white. Also, depending upon the selected input, one of the dialogs shown below will continuously scroll

through the screen.

4. This box also appears during normal system operation, if the video cable becomes disconnected or damaged. The monitor will enter Power Save Mode

after 5 minutes if left at this state.

5. Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor.

If your monitor screen remains blank after you use the previous procedure, check your video controller and computer, because your monitor is functioning

properly.

NOTE:

Self-test feature check is not available for S-Video, Composite, and Component video modes.

Built-in Diagnostics

Your monitor has a built-in diagnostic tool that helps you determine if the screen abnormality you are experiencing is an inherent problem with your monitor, or

with your computer and video card.

NOTE:

You can run the built-in diagnostics only when the video cable is unplugged and the monitor is in self-test mode.

Safety

Instructions.

Table of Contents