A/V Receiver Or Stereo System; Satellite Receiver Or Other Device With S-Video - Mitsubishi Electric HD-6000 Owner's Manual

Connecting an A/V Receiver or Stereo System or
a Satellite Receiver or Other Device with S-Video
A/V Receiver or Stereo System
Figure 7
A digital audio cable and stereo audio cables are required. The digital audio cable is provided. The stereo audio cables are not
included with the HDTV receiver/controller. "Y" splitter cables may also be required.
1_ Connect a set of stereo audio cables from OUTPUT to Display on the HDTV receiver/controller back panel to the
TV AUDIO INPUT on the back of the AiV receiver. The red cable connects to the R (right) channel and the white
cable connects to the L (left) channel.
Note: If you use OUTPUT to Display to provide audio signals to the speakers associated with your monitor, then
the audio output must be shared with the AiV receiver. Use RCA "Y" splitter cables to send analog audio to
both the AiV receiver and the monitor speakers.
To connect a digital A/V receiver with Dolby® Digital surround sound:
2_ Connect one end of the digital audio cable supplied with the HDTV receiver/controller to DIGITAL AUDIO on the
back of the HDTV receivericontroller. Connect the other end to the COAXIAL DIGITAL INPUT on the back of the
AiV receiver.
Check AiV receiver's Owner's Guide for information concerning the use of the digital input and switching
Figure Z
Connecting an A/V receiver
Satellite Receiver or Other Device with S-Video
Figure 8
An S-Video cable and audio cables are required. These are not included with the TV.
1_ Connect an S-Video cable from VIDEO OUT on the satellite receiver back panel to INPUT-2 VIDEO on the HDTV
receiver/controller back panel
2_ Connect a set of audio cables from AUDIO OUT on the satellite receiver back panel to INPUT-2 AUDIO, on
the HDTV receiver/controller back panel. The red cable connects to the R (right) channel and the white cable
connects to the L (left) channel.
Note: Refer to the Satellite Receiver Owner's Guide for Dish Antenna connections.
Figure 8. Connecting a Sate!rite Receiver with S-Video
Note: NetCommand® will asssume you connected your Satellite Receiver to Input-2. If you add a
second Satellite Receiver or use any other inputs for your Satellite Receiver, this change must match in the
NetCommand system. See Editing NetCommand Setup in Chapter 3 for more information.