Mitsubishi Electric HD-6000 Owner's Manual page 105

Troubleshooting, continued
PossibJe SoJution
40,
41,
An IEEE 1394 device has been plugged in but
does not appear in the Device Selection menu
(not discovered).
Cannot record to or from the IEEE 1394 device,
including Dub recordings.
42. Cannot control the IEEE 1394 device from the
Transport Menu.
43. When ChannelView rM list is displayed,
information appears incomplete
44. Program to be recorded was correctly selected ® The broadcaster supplied program information that was incorrect
from ChannelView, however, incorrect program and/or was changed after a recording was added to the Record List.
was recorded.
45. incomplete ChannelView program recorded.
46. ChannelView program recording failed.
® The IEEE 1394 connection to the HD-6000 or another device is not
secure or is loose.
The IEEE 1394 device is not powered on.
® A device in the IEEE 1394 chain is not powered on - turn on all the
devices.
The device discovery can take as long as a minute to initiate.
® IEEE 1394 cable is too long (maximum of !5 feet between devices).
® The IEEE 1394 device uses an incompatible protocol and will not be
discovered
® To initiate a recording to IEEE 1394 device press the REC key.
The Record menu displays allowing setup of the recording.
® The source device for the recording is not powered on.
® When dubbing, the destination device for the recording
is not powered on.
® The wrong media, (analog tape for digital recording, or
digital tape for the analog recording) is in the device.
® Either the program is copy protected, or if there are multiple
subchannels and one of the programs (not necessarily the
program requested) is copy protected.
® The program has already been recorded once and the copy
protection only allows one recording.
Unapproved source device for copy protected material.
® The recording device can not decode the copyright signal
included in the signal source (try another device if available).
® The playing device (for dubbing) does not support
copyrighted material.
Source for recording is copyrighted.
® Too many IEEE 1394 devices in network, insufficient
bandwith available. Disconnect unused devices.
® Source Device has higher speed (S 400) than record device, if
possible, reverse devices, play in the slower device and record
in the faster device.
® Device may not support the command.
Selected function is gray (such as Record for a DVD, which does not
support the Record function).
® Available information is sent from the broadcaster or cable provider.
No other data is available.
47. HD-6000 is not responding, after pulling out a
Memory card during playback with the LT-4260.
48. Can't see a thumbnail picture in the JPEG ® File does not meet file standards for playback.
menu, or can't see a track/song name in the
Playlist menu.
49. See on screen message "TV Disc is full..." ® Some recording(s) on the Track List need to be deleted. Press
DEVICE to display the Device Selection menu, then select TV
Disc. Press GUIDE to display the track list. Highlight program(s) to
delete and press CANCEL twice to confirm.
Recording device may have lack of space availability and there is not
enough blank space to make a full recording.
Connection and compatibility issues with IEEE 1394 (FireWire@)
digital devices. This may include too many Firewire devices in use at
one time, or the recording device not understanding the record
command.
® HD-6000 lost power long enough to lose current clock time.
® Analog VCR power was left Off.
® Press STOP or wait until playback is complete before removing
media card.
105