Mitsubishi WS-65807 Owner's Manual page 21

Part I1: Installation
Connecting a DTV Receiver
DTV Receiver with RGB Video
Connections
(Figure 2)
TV back p_nel
I_c°mEng A_te_,
B-_ or CabEe
[]
Figure 1. Connecting the DTV receiver with RGB video i
connections.
[] Connect the outside antenna, cable, or
satellite to ANT, or SATELLITE IN on the
DTV receiver (see your DTV receiver's
owner's guide for instructions, and cable
compatibility).
[] Connect the incoming terrestrial antenna,
or cable (not satellite) to ANT-A on the
TV back panel (a coaxil splitter, available
at most electronic supply stores, may be
required to complete this installation).
[] Connect the RGB cables from the DTV
receiver to the TV back panel as listed
below (if your DTV receiver uses BNC-
type cables, use the adaptors shown in
figure 1, page 20):
DTV Receiver TV Back Panel
G (green) = Y
R (red) = Pr
[] B (blue) = Pb
[] If the DTV receiver has outputs for H
and V sync, connect as listed below
(DO NOT connect if DTV receiver uses
"Sync on Green"):
H (horizontal sync)=
V (vertical sync) =
H
V
[] Connect the L (left) and R (right) audio
cables from the DTV receiver and to
DTV AUDIO on the TV back panel.
[] To utilize the benefits of a digital A/V
receiver, connect your DTV receiver's
digital audio out to a digital input on your
digital A/V receiver.
iiii_ii!_i_ _i_
ii::i;ii!ii_ i!!i