Little Wonder 2412 Owner's Manual And Safety Instructions

Single edged and double edged electric hedge trimmers

Advertisement

Quick Links

LITTLE
OWNER'SMANUAL and SAFETY INSTRUCTIONS
i_I
i _
_
i _ _
_
i _
_ i _
i
i
_ii_
Single Edged (Models
19!0, 2410,3010,
1912,2412,
30!2)
_nd Double Edged (Models !920, 2420, 3020, 1922, 2422, 3022)
Electric HedgeTrimmers
WARNING
DANGER
BLADES ARE EXTREMELY SHARP.
TO AVOID INJURY WHEN UNPACKING
THE HEDGE TRIMMER,
DO NOT GRASP THE BLADES.
(_
MANUEL DEL'UTILISATEUR INSTRUCTIONS DE
et
SECURITE
tranchant
unique
(modUles 1910, 2410, 3010, 1912, 2412 et 3012)
et _ double
tranchant
(modUles 1920, 2420, 3020, 1922, 2422 et 3022)
Taille-haies
_lectriques
AA TrSSEMEN ANCER
LES LAMES SONT
EXTREMEMENT
COUPANTES.
POUR EVITER DE SE BLESSER
PENDANT
LE DEBALLAGE
DE L!APPAREIL,
NE PAS LE SAISIR PAR LA LAME.
MANUAL DELPROPIETARIO e INSTRUCCIONES D E
SEGURIDAD
para las unidades con una sola cuchilla (modelos 1910, 2410, 30!0, 1912, 2412, 3012)
y las unidades con dos cuchillas (moddos 1920, 2420, 3020, 1922, 2422, 3022)
Podadora de arbustos dOctrica
_ AD VERTENCrA
I'ELIGRO
LAS CUCHILLAS
ESTAN
EXTREMADAMENTE
F!LosAs:
PARA
EVITARSE
UNA LESION
AL DESEMPACAR
LA PODADORA
DE ARBUSTOS,
NO LA
SOSTENGA
POR LAS CUCHILLAS.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 2412 and is the answer not in the manual?

Questions and answers

Summary of Contents for Little Wonder 2412

  • Page 1 LITTLE OWNER'SMANUAL and SAFETY INSTRUCTIONS WARNING DANGER i _ _ _ i _ _ii_ BLADES ARE EXTREMELY SHARP. Single Edged (Models 19!0, 2410,3010, 1912,2412, 30!2) TO AVOID INJURY WHEN UNPACKING _nd Double Edged (Models !920, 2420, 3020, 1922, 2422, 3022) THE HEDGE TRIMMER, DO NOT GRASP THE BLADES.
  • Page 2: Table Of Contents

    TABLE OF CONTENTS Page I. IMPORTANT INFORMATION A. Introduction ....................... II. GENERAL SAFETY RULES ................... A. Safety Decals ...................... B. Safety Symbols Identification ................C. Special Safety Rules ..................D. Warnings -- Dont's .................... E. Warnings -- Do's ....................Ill. UNPACKING ASSEMBLY INSTRU(;TIONS...
  • Page 3: General Safety Rules

    IL GENERAL SAFETY RULES 12) Do not overreach. Warl1111g: When using electric tools, basic safety Keep proper footing and balance at all tinres. precautions, including the following, should always 13) Maintain tool with care. followed to reduce the risk of fire, electric shock and Keep cutting tools shalt_ and clean for better...
  • Page 4: Safety Symbols Identification

    SAFETY DECALS AND MOLDED SYMBOLS Important parts of the safety system incorporated It is your responsibility to replace thedecals or molded both Single Edge and Double Edge trimmers are the housing when they become hard to read. The locations warning and informational decals and molded-in...
  • Page 5: Special Safety Rules

    BE AWARE!! The blades coast after triggers are SPECIAL SAFETY RULES released is switched off. Make sure blades motor have conle to a complete stop before letting go of a 1. Read and understand the owner's manual. handle. particular attention to all sections regarding safety.
  • Page 6: Ill

    Ill. UNPACKING ASSEMBLY INSTRUCTIONS WARNING DANGER BLADES EXTREMELY SHARE AVOID INJURY WHEN UNPACKING HEDGE TRIMMER, GRASP BLADES. H!ond_r Your Lit.tl_ hedge trimmer has been sure all fasteners are secure, and all guards and safety assembled for you at the factory. Before operating devices are in place and operating properly.
  • Page 7: Lubrication

    Read care and safety instructions carefully before extension cord over hedge being trimmed. On 120V attempting to use this trimmer. Only after you are units, use 16 gauge wire extension cord up to 100 feet. familiar with your hedge trimmer and all of its controls Over 100 feet use 14 or heavier gauge wire or extension...
  • Page 8: Service

    VL SERVICE TROUBLE SHOOTING Problem Cause Remedy 1. Blades don't cut cleanly. Blades are dull or not adjusted Have blades sharpened properly. adjusted. 2. Blades don't move when Blades are adjusted too tight. Re-adjust blades following turned service instructions. Worn brushes.
  • Page 9: Parts Explosions

    Single Edge Assembly iNSTALL WIRES FROM THROUGH WIRE TROUGH PART # DESCRIPTION QTY. 310100 Gear Housing Assembly {including pressed in pins / 16-54B Nut Lock 1/4-28 whiz Flange (for models 3010, 3012 / 30" SE 16-54B INut Lock 1/4-28 whiz Flange (for models 2410 2412} 24"...
  • Page 10 Double Edge Assembly & ® KEY # PART # DES CRIPTION QTY. 310100 Gear Housing Assembly iincludin_ pressed in pins} 16-54B Nut Lock 1/4-28 whiz Flange {for models 3020_ 3022) 30" DE 16-54B Nut Lock 1/4-28 whiz Flange ifor models 2420, 24221 24"...
  • Page 11 Gear/Motor Assembly < KEY # PART # DESCRIPTION QTY. 310100 Gear Housing Assembly 16-57A Gear Housing Cover Plate 310407 Grommet Rubber D16-71 Gasket Cover Plate 16-62 Eccentric Gear D16-59 Cluster Gear 16-64 Connectin _ Rod 16-65 Spacer Connecting 16-67 Felt 16-81-1 Screw 6-32 x 5/16 310503...
  • Page 12 Double Edge Front Loop Handle Assembly NORMALLY CLOSED BLACK WIRES SET OF 13) NORMALLY OPEN TO PC BOARD ATTACH RED KEY# PART# DESCRIPTION QTY. 3033 Switch Normally Open 310405 Switch Normally Closed 310219 Loop Handle Tri_er 310203 Loop Handle 310207 Shield 310504 Screw Plasti-Tite...
  • Page 13 Main Housing Assembly RED WIRES TO FRONT SWITCHES AT[ACH BLACK WIRE KEY # PART # DESCRIPTION QTY. 310400 Main Housing 310403 Housing Brush Cap Cover Plate 310404 Housin_ Loon Handle Cover Plate 310438 PC Board Assembly (for Models 3012, 2412 r 1912 / 310436 PC Board Assembly (for Models...
  • Page 14: Specifications

    SERVICE. Any Little Wonder Electric Hedge Trimmer or part found to be defective within the warranty period is to be returned to any registered Little Wonder Dealer. Transportation charges for parts and units submitted for replacement under this warranty nlust borne by the purchaser.

This manual is also suitable for:

192219203010191030202422 ... Show all

Table of Contents