Advertisement
"_7"our
TV remote can be set to
lwork
your VCR by what is
called the SEARCH
method.
lf the "REMOTE CODE" number
raethod shown in the previous
section did not set your remote to
_,ork your VCR, then follow the
five easy steps listed below.
Please read through steps 1-5
before beginning.
<_
Press the POWER button on
the VCR to turn VCR ON.
_
Stand at least six feet away
from the front of the VCR.
Point the remote toward the
VCR.
ItOLD DOWN the AJCH and
VCR System buttons at the same
time. KEEP HOLDING
BUqq'ONS DOWN.
@'
Watch the Channel Indicator
on the VCR.
Channel Numbers will SCAN UP
when the VCP, has becn
identified. This may take up to
lwo minutes.
q_
Release the tVCH and VCR
System buttons as soon as
channel nmnbers start to scan up.
The VCR code has been identified
and the remote is ready to operate
1he VCR.
,_'-
Remember. A minute or
two can seem very long, but
1:hecode should be located within
l:WO minutes.
Don't let the VCR scan up more
_:hanfive charmels. If you do the
_-emotemay pass up the right code
;andanother two minute search
cycle will have to be repeated.
[f no channel change happens
within two minutes, repeat steps
1-4. Should a channel change still
:not occur, the remote will not
work with the:desired VCR.
VCR
09
Don't let the VCR scan up
more than five channels
(in Search mode _.
g885
28
t
Six Feet
{minimum)
Advertisement
