Real-Time Counter Memory - Philips CCB092AT Owner's Manual

ReaiTimeCounter M emory41
• ooeeeeemee =mmeeeeeeeeeeoooeeeeemee =mmeeeeeeeeeeoooeeeeemee =mmeeeeeeeeeeoooeeeee,ee =mmeeeeeeeeeeoooeeeeemee =mm*
Follow the steps below to reset the real-time counter to zero at a _
tape location you want to refer to later.
Play, fast forward, or rewind a tape to the location that
you would like to refer to later. Stop the tape.
Press the STATUS/EXIT button. The real-time counter will
appear on the screen.
01:08 PM STOP_P_P_P_P_P_P_P_P_ _
C[ SLpIO 1 : 23 : 45
While the counter remains on the screen, press the
CLEAR button to reset the real-time counter to zero.
I 0:00:00
/
While the counter remains on the screen, press the MEM-
ORY button so that M appears on the screen. To erase a
real-time counter memory, press the MEMORY button so that the
M disappears from the screen.
I M 0:00:00
To go to a tape location where the real-time counter was
reset to zero, press the REW(ind)/_l button or the
F.FWD/I_ button when playback is stopped. When the
tape reaches the point at which the counter was set to
zero, the tape will stop. Press the PLAY/A button to
watch the tape.
Helpful Hints
• The real-time counter memory will
not function during Repeat Play
mode. Details are on page 38.
• You may only set one real-time
counter memory at a time. If you
set the real-time counter to zero at
a second location, the previous real-
time counter to zero setting will be
lost.