Advertisement
l_l_eckse make these simple
before calling for ser-
vice. These tips can save you
time and money since charges for
TV installation
and adjustment of
customer
controls
are
not
cov-
ered
under yourwarranty.
No Power
No Picture
No Sound
Remote Does Not
Work
TV Displays Wrong
Channel or NO
Channels Above 13
CAUTION: A video source (such as a video game, Compact Disc Interactive - CDI, or
TV information channel) which shows a constant non-moving pattern on the TV screen,
can cause picture tube damage. When your TV is continuously used with such a source
t
.
.
the pattern of the non-mov3ng portmn of the game (CDI, etc.) could leave an image
permanently on the picture tube. When not in use, turn the video source OFF.
Regularly alternate the use of such video sources with normal "IV viewing.
Check the TV power cord. Unplug the TV, wait 10 seconds, then reiusert plug into
|
outlet and push POWER button again.
I
Check to be sure outlet is not on a wall switch.
i Check antenna connections. Are they properly secured to the TV's ANT/CABLE plug ?It
Check the CABLE/YES
NO control for correct position.
]
Check INPUT control for correct position. The VCR-AUX position with
I
out a signal source will result in a blank screen.
I
i
heck the VOLUME buttons.
Check the MUTE button on the remote control.
If attempting auxifiary equipment hook-ups, check audio jack connections.
I
Check TV-VCR-CBL "System" buttons on the remote. Press the remote's TV System
button to send commands to the TV.
Check batteries. Replace with AAA Heavy Duty (Zinc Chloride) or Alkaline batteries
if necessary.
Clean the remote and the remote sensor window on the 'IV.
Check the TV power cord. Unplug the TV, wait 10 seconds, then reinsert plug into
outlet and push POWER button again.
Check to be sure TV outlet is not on a wall switch.
Repeat channel selection.
Add desired channel numbers (CHANNEL control) into 'IV memory.
Check CABLE/ YES NO conu:ol for correct position.
I
This TV is equipped with protective circuitry that shuts the TV off in case of moderate
power surges. Should this occur turn the TV back on by pressing the POWER button
once or twice, or unplug (wait 10 seconds) and then replug the power cord at the AC
outlet. This feature is NOT designed to prevent damage due to high power surges such
as those caused by lightning, which is not covered by your warranty.
Cleanin_ and Care
• To avoid possible shock hazard be sure the TV is unplugged from the electrical outlet before cleaning.
• When cleaning the "IV screen take care not to scratch or damage the screen surface (avoid wearing jewelry or using
anything abrasive). Wipe the front screen with a clean cloth dampened with water. Use even, easy, vertical strokes when
cleaning.
• Gently wipe the cabinet surfaces with a clean cloth or sponge dampened in a solution of cool clear water. Use a clean
dry cloth to dry the wiped surfaces.
• Occasionally vacuum the ventilation holes or slots in the cabinet back.
• Never use thinners, insecticide sprays, or other chemicals on or near the cabinet, as they might cause permanent marring
of the cabinet finish.
19
Advertisement
