Table of Contents
Advertisement
CABLE
OR ANTENNA
OUTPUT
O
IOUT
(TO TV)
Cable box
ANTENNA
CABLE
Aw
(_
AV3_
L+R+VIDEO
®
i! i
Cable
box
Watching
cable TV
programs
that don't
require the use of a cable box.
Since you've connected the cable TV signal
directly to the TV's tuner, you can also watch
unscrambled programs by simply tuning to
the desired channel: however, you must first use
Auto program to store available channels in the
TV's memory. (p. 13)
Note: This connection will supply stereo s0una to t_e
TV i _the station you are wew_n_ broadcasts stereo
soun(i'
= Cable
TV
Connect
the cable TV signal to the CABLE/
ANTENNA
75 _'_r
jack at the bottom
of the TV.
See page 13 for details on using Autoprogram
to store
channels in the TV's memory.
Note: This connection will supply stereo sound to the TV if
the station you are viewing broadcasts stereo sound.
= Cable
box with RF INIOUT
• Connect
the incoming
cable TV signal to the cable IN
jack (_) on the back of the cable box.
• Connect
a coaxial cable (not supplied) from the TO TV
jack on the back of the cable box to the CABLE/
ANTENNA
75 _ -_r" jack (_) at the bottom
of the TV.
Note: "four cable box may have a different label for the TO
TV jack. Commonly used labels include OUTPUT
or OUT.
• Set the OUTPUT
CN switch (_) on the cable box to CH
3 or 4 (whichever
is correct
for your cable box), Next,
tune the TV to the corresponding
channel. Once
tuned, change channels using the cable box, not the TV.
Note: This connection will not supply stereo sound to the TV. The
reason is that the RF output on a cable box - labeled TO T_ OUT
or OUTPUT
for example ,- will not send a stereo signal to the tuner
(VHF/UH_I
input on a TV.
= Cable
box
with
AIM
outputs
• Connect
the incoming
cable TV signal (_) to a signal
splitter
(not supplied). The signal splitter
enables you to avoid
having to use the TO TV jack on the back of the cable box.
This jack will not supply stereo sound to the TV.
Note: Your cable box may have a different label for the TO
TV jack. Commonly used labels include OUTPUT
or OUT.
• Connect
a coaxial cable (not supplied) to a connector
on
the signal splitter
and to the CABLE/ANTENNA
75
-_r- jack O on the TV.
• Connect
another
coaxial cable (not supplied) to a
connector
on the signal splitter
and to the cable IN jack O
on the back of the cable box.
• Connect
A/V cables (not supplied) to the VIDEO
IN and
AUDIO
L and R outputs
on the back of the cable box
and to the AV3 video (labeled VIDEO
IN) and AUDIO
(labeled L and R) jacks (_) on the back of the TV.
• To view programs
from your cable box, first press the
SOURCE
button
on the remote
control.
• Press the cursor down or up buttons
until the AV3 signal
source is selected.
• Press the OK button
to confirm
your selection.
The AV3
input source becomes current
for the viewing of cable TV
programs
through
your cable box.
Note: If your cable box audio/video outputs do not supply
video and stereo audio to the TV, you will need to make the
connection shown above in "Cable box with RF INIOUT.
Advertisement
Table of Contents
