To Assemble; To Attach; To Use Clips - KitchenAid SNPA Use & Care Manual

TO ASSEMBLE:
m
/
/
B
C
.
A _
/
I
0 0
/E
_i,i_ i i:')?,',_iii_i
D
G F
Insert the grind worm (A) into the grinder body (B).
Place
one of the pasta plates
(C) over the exposed end of the grind worm, matching the tabs of the plate with
the notches in the grinder body. Place ring (D) onto grinder body, turning by hand
until finger tight but not overtightened. Wooden food pusher (F). A storage case
(G) is provided to store pasta plates, bowl clips (H) and cleaning tool (l).
Note:Do not
use wrench (E) to tighten ring.
TO ATTACH:
2
Before attaching accessory, turn off
and unplug unit.
Loosen attachment knob (]) by turn-
ing it counterclockwise. Remove
attachment hub cover. Insert attach-
ment shaft housing (2) into attachment
hub (3) making certain that attach-
ment power shaft fits into square hub
socket. Rotate attachment back and
forth if necessary. When attachment
is in proper position, the pin on the
attachment will fit into the notch on
the hub. Tighten attachment knob
until attachment is completely
secured to mixer.
FOR 5 QUART MODELS*
Two, small, metal clips (H) have been
packed with this attachment. These
clips are to be used only when making
the pasta dough recipes.
To
use clips
Once bowl has been
attached to the mixer,
place the clips over the
locating pins. These clips help keep
the bowl stationary during mixing.
**5 Quart models include KSSS, KSMS,
KSM50P.