Slide Keys/Program Keys; Stitch Width Slide Key; Stitch Length Slide Key; Balance Slide Key - Pfaff tiptronic 6270 Instruction Book

Slide keys/program keys
Any time a new program is selected the machine
adjusts itself to the corresponding default setting.
Stitch width slide key (7)
Stitch width and needle position are determined by
means of this slide key.
Stitch length slide key (8)
With this slide key you can determine stitch length
or stitch density. In case of program 70 this key is
for determining the buttonhole length.
Balance slide key (9)
With this slide key you can determine the balance
or the pattern length.
±
Program key tens digits (26)
With toggle switch
"+"
you can browse through
the program jumping 1 0 programs at a time. The
same goes for the alphabet, the numbers and the
pattern sequence. With toggle switch
"-"
the
selection can be carried out in reverse order.
±
Program key for unit digits (0 to 9) (1 3)
With toggle switch
"+"
you select a pattern num
ber from 00 to 74. After 74 the selection starts
again from 00. With toggle switch you select a
pattern number in reverse order starting from 00
and continuing with 74, 73 etc. With toggle
switches
'+/—"
it is also possible to switch inside a
selected group (alphabet or numbers) from one
item to another.
ni)
Patten sequence memory key (1 5)
With this key the pattern, alpha-numeric or special
character shown on the display are saved in the
memory. When saving the symbol m lights up
for a short time.
37