Opel Automobile Owner's Manual page 167

3. Ensure the jack is positioned
correctly with the vehicle jacking
points.
With versions of the Corsa OPC
with sill panelling or retrofitted sill
panelling no jack must be used.
The vehicle may be damaged.
4. Set the jack to the necessary
height before positioning it directly
below the jacking point in
a manner that prevents it from
slipping.
Vehicle care
Attach jack handle and with the
jack correctly aligned rotate
handle until wheel is clear of the
ground.
5. Unscrew the wheel bolts.
6. Change the wheel.
7. Screw in the wheel bolts.
8. Lower vehicle.
9. Install the wheel wrench ensuring
that it locates securely and tighten
each bolt in a crosswise
sequence. Tightening torque is
110 Nm.
10. Align the valve hole in the wheel
cover with the tyre valve before
installing.
Install wheel bolt caps.
11. Stow the replaced wheel 3 162
and the vehicle tools 3 158.
12. Check the tyre pressure of the
installed tyre and also the wheel
bolt torque as soon as possible.
Have the defective tyre renewed or
repaired.
167