Wheel Changing - Opel Automobile Owner's Manual

124 Vehicle care
Note
The driving characteristics of the
repaired tyre is severely affected,
therefore have this tyre replaced.
If unusual noise is heard or the
compressor becomes hot, turn
compressor off for at least
30 minutes.
The built-in safety valve opens at
a pressure of 7 bar.
Note the expiry date of the kit. After
this date its sealing capability is no
longer guaranteed. Pay attention to
storage information on sealant
bottle.
Replace the used sealant bottle.
Dispose of the bottle as prescribed
by applicable laws.
The compressor and sealant can be
used from approx. -30 °C.
The adapters supplied can be used
to pump up other items e.g.
footballs, air mattresses, inflatable
dinghies etc. They are located on the
underside of the compressor. To
remove, screw on compressor air
hose and withdraw adapter.

Wheel changing

Some vehicles are equipped with
a tyre repair kit instead of a spare
wheel 3 121.
Make the following preparations and
observe the following information:
■ Park the vehicle on a level, firm and
non-skid surface. The front wheels
must be in the straight-ahead
position.
■ Apply the parking brake and
engage first gear or reverse gear.
■ Remove the spare wheel 3 127.
■ Never change more than one wheel
at once.
■ Use the jack only to change wheels.
■ If the ground on which the vehicle
is standing is soft, a solid board
(max. 1 cm thick) should be placed
under the jack.
■ No people or animals may be in the
vehicle when it is jacked-up.
■ Never crawl under a jacked-up
vehicle.
■ Do not start the vehicle when it is
raised on the jack.
■ Before screwing in the wheel bolts,
clean them and lightly coat the
taper of each wheel bolt with
commercially available grease.
1. Prise off the hub cap using
a screwdriver, positioning the
screwdriver at the recess at the
side of the hub cap. Vehicle tools
3 118.
Pull off the wheel cover with the
hook. Vehicle tools 3 118.