Opel Automobile Owner's Manual page 123

6 bar. Then the pressure starts to
drop.
All of the sealant is pumped into
the tyre. Then the tyre is inflated.
13. All of the sealant is pumped into
the tyre. Then the tyre is inflated.
14. The prescribed tyre pressure
should be obtained within
10 minutes. Tyre pressure
3 150. When the correct pressure
is obtained, switch off the
compressor.
If the prescribed tyre pressure is
not obtained within 10 minutes,
remove the tyre repair kit. Move
the vehicle one tyre rotation.
Reattach the tyre repair kit and
continue the filling procedure for
10 minutes. If the prescribed tyre
pressure is still not obtained, the
tyre is too badly damaged. Seek
the assistance of a workshop.
Release excess tyre pressure
with the button over the pressure
indicator.
Do not run the compressor longer
than 10 minutes.
15. Detach the tyre repair kit. Screw
the filler hose to the free
connection on the sealant bottle.
This prevents sealant leakage.
Stow the tyre repair kit in the load
compartment.
16. Remove any excess sealant
using a cloth.
17. Take the label indicating
maximum permitted speed from
the sealant bottle and affix in the
driver's field of view.
18. Continue driving immediately so
that sealant is evenly distributed
in the tyre. After driving approx.
10 km (but no more than 10
Vehicle care
minutes), stop and check tyre
pressure. Screw compressor air
hose directly onto tyre valve and
compressor when doing this.
If tyre pressure is more than
1.3 bar, set it to the correct value.
Repeat the procedure until there
is no more loss of pressure.
If the tyre pressure has fallen
below 1.3 bar, the vehicle must
not be used. Seek the assistance
of a workshop.
19. Stow away tyre repair kit in load
compartment.
123