Warranty - Kenmore 583.35600 Owner's Manual

WARRANTY
ASSEMBLY
Your heater was shipped fully assembled except for the fuel tank cap and gasket to eliminate the possibility of conden-
sation in the tank. Remove the cap from the plastic bag and install on the tank.
SAFETY COMPLIANCE
Safety requirements and model plate data comply with AMERICAN NATIONAL STANDARD INSTITUTE, INC.
Safety Requirements: ANSI A10.10-1981.
HOW TO USE YOUR HEATER
ELECTRICAL INFORMATION
(The round prong on the plug is for the ground wire).
Older homes, having a 2-wire system, will require that an
adapter, with ground, be used at the outlet. These are
available at your local Sears store. They must be used in
accordance with proper grounding instructions.
Only plug heater into 3-wire extension cord which
plugs into standard household 3-prong outlet or
properly installed adap ter.
This heater only works on standard household current
which is alternating (AC), not direct (DC), and provides
120 volts, 60 hertz. The heater uses 2.8 amperes when in use.
The standard plug, on the heater cord, is a three prong
type which mates with standard household outlets used
with standard 3-wire systems; the third wire being a ground.
Only use electrical extension cords as described
below.
Extension cord must be a 3-wire (grounded) cord of proper
wire size, as shown in the following table.
CORD LENGTH(FT). 0to75 75to125 125 to 200
MIN. WIRE SIZE (AWG). No. 18 No. 16 No. 14
FUEL SPECIFICATIONS
Never fill heater fuel tank while heater is plugged
into outlet.
Never use gasoline, naphtha, paint thinner, alcohol,
or other volatile liquids as fuel.
This heater operates on kerosene or No. 1 fuel oil. These
fuels are sold at your local fuel oil supplier or service
station.
Cold temperatures may cause fuel to thicken. If so, move your
heater to a warmer environment until fuel flows freely.
3