Frigidaire CRA054XT72 Use & Care Manual page 8

Operating Instructions
(continued)
TO CHANGE TEMPERATURE DISPLAY:
temp_timer
cool auto
menergy saver mhi
fan only
lo
DO THIS:
PRESSAND HOLD
THE UP/DOWN
BUTTONS TOGETHER
FOR 3 SECONDS
YOU WILL SEE:
temp/timer
cool auto
menergy saver mhi
#n only lo
®
Note: The control is capable of displaying temperature
in degrees Fahrenheit or degrees Celsius.
FAULT CODES
f
temp/timer
cool aut_
menergy saver mhi
jan only lo
®
\ /
If the display reads "AS",
a sensor has failed. Contact
your Authorized Frigidaire
Service Center.
TO TURN UNIT OFF:
temp/timer
cool autc
energy saver hi
0
ADDITIONAL THINGS YOU SHOULD KNOW
Now that you have mastered the operating procedure, here are more features in your control that you should become familiar with.
• The "Cool" circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. /_
This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue
to run during this time.
• There is a 2-Second delay for the compressor shutting down when selecting FAN ONLY. This is to cover the possibility of having
to roll through to select another mode.
• The control will maintain the set temperature within 1 degrees Celsius, between 16 °C and 32 °C.
• After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored.
AUGER WHEELS
Air Directional Louvers
Air directional louvers control air flow direction. Your air conditioner has the louver
type described below.
8
Auger Type
The louvers will allow you to direct the air flow Up or Down and Left or Right
(8-WAY) throughout the room as needed. Rotate the Auger Wheels until the desired
Left/Right direction is obtained. Pivot horizontal louvers until the desired
Up/Down direction is obtained.
02009 Electrolux Home Products, Inc. All rights reserved.