Setting The Clock; Defrost By Weight - Emerson MW8119SB Owner's Manual

SETTING THE CLOCK
1. Touch the CLOCK pad.
The display will show "ENTER CLOCK TIME".
NOTE: When the unit is t_rs[ plugged in, it will temporarily
be in the clock set mode.
2. Enter the correct time of day.
EXAMPLE: To set the time to "10:02", touch "1 _, "0", "0",
"2" in sequence.
The display will show the numbers pressed in the order
in which you pressed them.
3. Touch the CLOCK pad.
The display witl show the present time and the colon will
stop blinking. After the clock has been set, the time will
appear unless the oven is cooking or defrosting.
_J
LOCK
C °
Lo_
! Lq • LI
J
_L_* Ltm_
I" To reset present time in the display window when the oven is off, touch the CLOCK pad and reset.
_t • A pad must be touched within 15 seconds when setting the clock, or entering cooking information.
i
_, If you make a mistake when selling the time, touch the RESET pad.
i
',, To recall the actual time while the oven is cooking or defrosting, simply touch the CLOCK pad and the display will
t show the actual time for three seconds.
DEFROST BY WEIGHT
DEFROST BY WEIGHT lets you easily defrost foods by eliminating guesswork in determining defrosting time.
The minimum weight for Auto Weight Defrost is 1oz. The maximum weight is 6.0 Ibs (entered as 51bs, 16oz).
Follow the steps below for easy defrosting,
',IMPORTANT NOTE: The oven beeps during the defrosting cycle to signal that the food needs to be turned
i
',or rearranged, when the defrosting time ends, you will hear 4 beeps.
,,
1. Touch the DEFROST BY WEIGHT pad.
2. Using the keypads, enter the pounds, and then enter the
ounces.
For example, for I pound 5 ounces, touch "1", "0", "5".
(Maximum weight that can be entered is 51bs, 16oz.)
I
_ o ,_ ,,
La 0Z
3. Touch the STARTISTOP pad. The display will show "CODE"
and "DEF" and count down the remaining defrosting time in
minutes and seconds. It will beep four times and show "End"
when defrosting is completed (refer to Important Note
above). Touch the RESET pad or open the door to clear
before starting another operation.
I,,
CODE
lq:2G
OEF