Table of Contents
Advertisement
Upper Pulley.
Half
Tab.
Belt
Guard
Half
Lower Pulley
Half_
Belt
Belt
Guard Pin
Figure 20
Pivot the control arm back to its original position
and reinstall the six-speed cable into the slot.
See Figure 21.
Check and make sure the belt is routed inside the
pulley halves and the belt guard pin.
Six-Speed
Cable
O
.=y
Reinstall the bolt securing transmission to rear
mower housing.
Pivot the baffle back to its original position and
secure with three hex screws removed earlier.
Lightly lubricate the inside of the blade adapter and
reinstall the spacer, wave washer, blade adapter
assembly, and blade in the correct order.
Tighten the hex bolt to secure the blade to torque:
450-600 in. Ibs.
Storing yourLawnMower
The following steps should be taken to prepare your
lawn mower for storage.
Clean and lubricate mower thoroughly as described
in the lubrication instructions.
IMPORTANT:We do not recommend the use of a
pressure washer or garden hose to clean your unit.
Refer to engine manual for correct engine storage
instructions.
Coat mower's cutting blade with chassis grease to
prevent rusting.
Store mower in a dry, clean area. Do not store next
to corrosive materials, such as fertilizer.
NOTE: When storing any type of power equipment in a
poorly ventilated or metal storage shed, care should be
taken to rust-proof the equipment.
Using a light oil or
silicone, coat the equipment, especially cables and all
moving parts.
Control
Arm
Figure 21
16
Advertisement
Table of Contents
