Advertisement
Drying temperature too high
• Operating thermostat
Check for lint that may insulate thermostat from
exhaust air. Check thermostat for function.
Motor runs with door open
• Door switch
Check door switch for function and switch clip
actuating arm for proper switch plunger actuation.
Noise
• Loose components
Secure component.
• Idler assembly
Check alignment and bearing assembly.
• Belt
Replace belt.
• Motor
Check motor.
• Lint
Remove lint from rear drum groove.
• Front drum bearings
Lubricate or replace bearings. If loose, fasten Delrin
bearing ring to drum flange with silastic or, if needed,
replace Delrin ring.
• Support roller assemblies
Replace roller and/or shaft.
• Baffle
Tighten assembled baffle.
• Blower
Foreign matter in blower housing.
Clothes
"bailing"
complaints
• Large garments
(sheets, spreads)
"bailing"
instead of tumbling
Check to see if dryer is being overloaded. Check
drum speed (48 + 3 RPM).
If you need an additional parts list, contact your
nearest Sears Service Center or Parts
Department. Make sure to order by complete
Model Number when ordering.
CHANGING
VEND PRICE?
To change vend price, detach and mail the lower
portion to: Customer Service Department
Greenwald Industries Inc.
212 Middlesex Ave.
Chester, CT 06412
THE COIN CHUTE HAS BEEN PRE_SET AT THE FACTORY
WHEN INCREASING IN $.25 PRICING
Follow instructions on page 10--no extra parts required.
WHEN DECREASING
IN $.25 PRICING
or
CHANGING TO $.10 PRICING
(coin sizing block required, see page 11)
Order required parts using this tear-off. Block-out keys
will be shipped to you at no charge. Follow product
information instructions.
QUANTITY: _
EXISTING VEND PRICE $
NEW VEND PRICE $
NAME
COMPANY
ADDRESS
CITY
DAYTIME PHONE
PURCHASE
DATE
14
Advertisement
