Frigidaire FAFW3514KN1 Use & Care Manual page 10

Deep Clean
Sa_ze
Heavy
Whitest Whites
NormaL/CasuaL
Quick
DeUeates/Hand Wash
Spin Only
• 0 _ Sanitize @ Maximum
Auto 0 Hot/CoM © Fast ® Energy Saver
Temp @ Warm/CoW 0 Medium @ Extra Rinse @ Heavy © Door Lock
@ Rinse
• O CoLd/Cord @ Stow © Stain CLean @ Normal @ Final Spi_
@ Cold/Cord @ No Spin @ Signal VoLume @ Light © Touch Pause to Add a Gamlent
Temperature Spin Speed
Options _ Soil Level Start/Pause
This manual covers many models and not all cycles, options, or features listed are available
on every model. Console shown above for reference only. Your model may differ.
Cycle Selection
Turn the cycle selector in either direction to the cycle
desired. The indicator for that cycle will be illuminated.
For best results Follow the fabric care label instructions
on items to be washed.
To change the cycle once it has begun, press the cancel
button before selecting a new cycle. ]ust turning the
cycle selector knob to another selection will not change
the cycle. If the selection is changed after the cycle
starts, the indicator lights will blink, the signal will beep
and "Erff' will be displayed. The signal will beep and the
status lights will flash, but the original cycle will continue.
Deep Clean Sanitize (on select models)
Use this cycle to clean heavily soiled, colorfast fabrics
including towels, bedding, children's clothing or other
items where sanitization is desired. This cycle combines
super hot water temperature and fast speed tumbling
to help ensure the removal of heavy soils and stains.
It is recommended that you set your hot water heater
to 120F (49C) to ensure proper performance during
the cycle. If the setting is lower, the cycle time will be
extended by 30 minutes or more.
The Deep Clean Sanitize cycle will kill 99.9% of
bacteria with no carryover of bacteria between loads.
No bleach or harsh chemicals are required, but
higher temperatures are required. Please check fabric
care labels to prevent damage. Only the Sanitize
temperature setting is available.
This cycle has been certified by NSF International,
an independent third party testing and certification
organization dedicated to public health, safety and
environmental protect!on- ..........................................................................
[_ NSF Protolcol P172
/ _II_L /Sanitization Performance of Residential
\ II1_,_ _ ..../and Commercial, Family-Sized Clothes
\_ Washers
The wash water is heated by an internal boost heater
to a maximum of 152 ° F as the load tumbles for up to
90 minutes. "_Rn" is displayed during the wash phase
alternately with the estimated cycle time. Cold water is
added to cool down the load prior to drain and spin,
If the voltage at your outlet is under 110 v, the internal
heater may not adequately heat the wash water. If
the cycle is interrupted while the water is heating, the
final temperature of the wash water may be lower and
san!tat!on may be reduced: ........................................................................
As a precaution, the washer door is locked once the
water temperature reaches 130 ° R If the cycle is
cancelled during the wash phase and if the water
temperature is greater than 150 ° F, an automatic cool
down and drain will occur before the door can be
opened. '_d" will be displayed.
I-lead/
The Heavy cycle provides 20 minutes of reversing
tumble wash action for heavily soiled items. Hot water
is recommended to remove heavy soil and most stains.
Stain Clean, Extra Rinse, Energy Saver (on select
models) and Extended Spin (on select models) are
available options.