Table of Contents
Advertisement
UsingRecordingTimer
With Recording
Timer, you can make a tape of a radio
broadcast
automatically.
You can set the timer whether
the
unit is on or off.
HowRecordingTimer actuallyworks
The unit automatically
turns on, tunes in to the specified
station,
sets the volume level to "VOL MIN," and starts
recording
when the on-time
comes
(the O indicator
flashes
while the timer is operating).
Then, when the off-time
comes,
the unit automatically
turns off (stands by).
Recording
Timer works only once, but the timer setting
remains
in memory
until you change
it.
• There is a time limit in doing the following
steps. If the
setting is canceled
before
you finish, start from slep 2
again.
• If you have made a mistake
while setting the timer, press
CANCEL/DEMO.
(However,
this does not always work. If
CANCEL/DEMO
does not work, press CLOCK/TIMER
repeatedly
and start from slep 2 again.)
On the unit ONLY:
/ Put a recordable
cassette into deck B.
2 Press CLOCK/TIMER
repeatedly
until "REC"
appears on the display.
O indicator
lights up and the REC (recording
timer)
indicator
starts flashing on the display.
Ii! o
r--r-
c'L
• Each time you press the button,
the clock/timer
setting
modes change as follows:
--_,,,,, DAILY _
ON TIME _
REC 7
(Daily Timer)
l
Canceled _CLOCK-_---
ON TIME -_-J
(See page 9)
(Recording
Timer)
3
Press
CLOCK/TIMER
again.
"ON TIME" appears for 2 seconds, then
the unit enters on-time setting mode.
4 Set the on-time
you want the unit
to turn on.
1) Turn the t,41_/1_-t control to set the
hour, then press SET.
2) Turn the t,41_/1_-t control to set the
minute, then press SET.
"OFF TIME" appears
for 2 seconds,
then the unit enters off4ime
setting
mode.
5 Set the off-time
you want the unit
to turn off (on standby).
1) Turn the I-,ll_/It..t_t control to set the
hour, then press SET.
2) Turn the I-,11_1/1_-Icontrol to set the
minute, then press SET.
The unit enters preset station selecting
mode.
6
Select
the preset
station.
1) Turn the I-_l_/It..t_tcontrol to select the
band ("TUNER FM" or "TUNER AM"),
then press SET.
2) Turn the I-_l_l/It..t_t c ontrol to select a
preset channel number, then press SET.
The REC (recording timer) indicator stops
flashing and remains lit. The settings you
have done are shown on the display in
sequence for your confirmation.
7 Press 0/1 to turn off the unit (on
standby)
if necessary.
_
About
the recording
source
If you change
the source
while recording,
the recording
source
also
changes.
27
Advertisement
Table of Contents
