Remote Controls; Power - JVC AV-27D500 User Manual

I GETTING STARTED
REMOTE CONTROLS
RM_-343 RM-C342
AV-32D500 • AV*27E_00 AV-320200 • AV-27D2(X)
CHANGING THE BATTERIES
Be sure to use on/y size AA batferfes.
] Push down on the remote's back cover and stide
towards the bottom to remove it.
] Insert the two supplied AA battaries, carefully noting
the "+" and "-" rrlarlengs on the batteries and remote
control.
] TO avoid a short circuit, insert "-" end first. Slide the
cover back into place (until it clicks into position).
0 If the remotB contr_ a_ts erratical, tepfece the bat_fies.
Typical battery life i_ usuaJ_ about six months to one yeaK
£3 We recommend alkaline batteries for a fenger battery life.
NOllE:
When you change the batteries, try to complete the task
w_in 3 minutes, ff it takes leng_r than 3 minutes, the remote
control c_des for your VCR and/or Cable box will have to be
reset (page 12).
GETTING STARTED
POWER
O Make sure that the TV/CA_/sw_h is set to TM Switoh to CAW _Jy to operate a cable box.
£3 press the Powm button cn _e remote contrc_or the TV front penel. The On T, ner letup wili glew rod.
O The first time you turn on the _ the "Rug In Menu" will appea_ you should turn to the Plug In
Menu section (page 15) now to learn more abo4Jt this menu.
To turn the power off, press the Pow_ button again. The On Timer Jampwill go out.
O When the TV is off, the OnTimer lamp remains on while the On/Off Timer function is active, but at a
reduced brightness.
ADJUSTING VOLUME
[] Use the V__UME-{-_ buttons ( •• ) on the front panel or remote control. Use the VOLU_E- ( • )
button to lower the voJume. Press the VOLUME ÷ button ( • ) raise the volume.
:::::::::::::
] Press the MVnNGbutton to instantJy torn the volurne off to zero. To restore the volume to the
previous volume level, simply press the MU11NG butlon again.
CHANGING CHANNELS
[] lO _ dl_ =:_.
Press the numbers on the rernote_ tO key pad. For single<tigit channel numbers press 0 then the
number. For chennels above 100, pre_ the 100+ button plus the 2-digit number.
[] ChIHyl_w _mn button.
*Ibs_n tbed_ one _ a free, press t har_'s C_ So_ bu_ 8_d re_.
• To _an mrough the chr, neb ray e/_dy, h_d dovm the remote's C_,#,-M_m , Sc_ I:x_:_.
Ntef two channeb go by at hemal speed, _e n_t of 1hechanr_ v_llspeed by at the rate @ f_
chonr_ p_ _ You_I n_ seei_ _ thechonn_ mty thechoag_ng _ nurnbem_
theho_om of thescm_
[] Return.
Press and release the RE_JRN+button tOreturn to the previous channel. First, select a channe_
(game #1). Then, select another channel (game #2) with the 10 key pad and push the RE1_RN+
button to flip directly back and forth.
[] Return+.
Press and hold down the RETURN+ button for three seconds. The message, =RETURN CHANNEL
P_OGP.N_MED !" witt _pbaar and you cart scar_ as you wisP,.Press _+ again a_d you will go
back to the Return+ channeL
To cancel a Return+ channel, press and hold down the RE']_IRN + button for another three seconds
and the _age, "RETURN CHJ_NNEL CANCELLSD !" appears.
0 Pressing a number key Or temlng the set off v_/siso cancel a Return+ channel