information Fin i PLEASEREADAND SAVETHIS GUIDE • • • • • • • • • • • • • • • • • • • • • Thank you for choosing Electrolux, the new premium brand in home appliances. This Use & Care Guide is part of our commitment to customer satisfaction product quality throughout...
ing Information PRODUCT REGISTRATIONINFORMATION • • • • • • • • • • • • • • • • • • • • • • The package containing this manual also includes your product registration information. Warranty coverage begins at the time your Electrolux vent hood was purchased.
Safety IMPORTANT SAFETYINSTRUCTIONS • • • • • • • • • • • • • • • • • • • • • • Safety Precautions Do not attempt to install or operate your unit until you have read the safety precautions in this manual.
Gettin Started OPERATING YOURHOOD • • • • • • • • • • • • • • • • • • • • • • Controls The hood is operated using the (5) push-buttons located at eye-level, on the front edge of the hood.
Page 10
Operation Halogen Bulbs This range hood requires two halogen bulbs (Type JC, 12Volt, 20Watt Max, G-4 Base). To change bulbs: 1 Open the cover by prying from the proper slots. 2 Remove the bulb by pulling sideways. (DO NOT ROTATE). 3 Replace with Type JC, 12Volt, 20 Watt Max, G-4 Base halogen bulb.
Care and Cleanin CARING FORYOUR RANGE HOOD • • • • • • • • • • • • • • • • • • • • • • Proper maintenance of the Range Hood will assure proper performance of the unit. Grease Filters The grease filters...
installation INSTALL THE DUCTWORK • • • • • • • • • • • • • • • • • • • • • • 1 Decide where the ductwork will run between the hood and the outside. 2 A straight, short duct run wilt allow the hood to perform most efficiently.
Installation PREPARETHE HOOD • • • • • • • • • • • • • • • • • • • • • • Note: On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces of the hood and decorative flues, prior to final installation, DuctedHoods Only...
Page 17
i!iiii!iii i Installation Non-DuctedHoodsOnly 1 Remove the tape on the electrical system plate; place the electrical system plate on the hood (use a protection). Figure 12 ..2 Discard discharge collar/damper supplied with the hood. Install the 5 to 6 adapter supplied with the Non-Uucted Recircutation...
Installation INSTALLTHE HOOD • • • • • • • • • • • • • • • • • • • • • • 1 Raise the hood into its mounting position. 2 Align the rectangular opening on the back of the hood with the walt-mounting bracket.
Page 19
i "1!i!!i!iiiilfiiiiliiii i!!il iii i! !!!!i installation 9Carefully place the decorative f_ue on the hood, Rgure _6, - On ducted installation in rooms with 8-foot ceilings, the air vents are concealed. Install the flue with the air vents down. - On non-ducted installations in rooms with 8-foot ceilings, the air vents are...
Troubleshootin IF SERVICE IS REQUIRED • • • • • • • • • • • • • • • • • • • • First, review the recommended checks listed in the Troubleshooting Guide. Then, be certain that the appliance has been installed properly and is being...
Troubleshooti TROUBLESHOOTINGGUIDE • • • • • • • • • • • • • • • • • • • • • • Troubleshooting: What to check when problems occur Problem Possible Cause Remedy Nothing works. Vent power supply Have electrician check power supply, interrupted or not energized.
Savin Energy ENERGYSAVINGTIPS • • • • • • • • • • • • • • • • • • • • • • Do not operate the blower at a speed that is higher than necessary remove the cooking exhaust.
rraoty HO00 WARRANTY Your hood is protected by this warranty WARRANTY THROUGH O UR AUTHORIZED SERVICERS, THECONSUMER WILLBE i pER,CO WEW,LL: I RESPONS,BLEFOR: FULLONE-YEAR I Oneyearfrom I Payallcostsfor repairing o r replacing a nyparts ofthis I Costs of service callsthatarelistedunder WARRANTY original purchase product which prove to bedefective inmaterials or...