Husqvarna 917.384502 Owner's Manual page 13

160cc honda engine 21" multi-cut rotary lawn mower
Table of Contents

Advertisement

Available languages

Available languages

Check the crankcase oil level before
starting the engine and after each five (5)
hours of continuoususe. Tighten oil plug
securely each time you check the oil level.
TO CHANGE ENGINEOIL
NOTE: Before tipping lawn mowerto drain
oil, empty fuel tank by running engine until
fuel tank is empty.
1. Disconnectspark plug wire from spark
plug and place wire where it cannot
come in contact with plug.
2. Remove oil fill cap/dipstick;lay aside
on a clean surface.
3. Tip lawn moweron its side as shown
and drain oil into a suitable container.
Rock lawn mower back and forth to re-
move any oil trapped inside of engine,
Replacethe air filter every 100 hoursof
operation or every season, whichever oc-
curs first. Service air cleaner more often
under dusty conditions.
TO CLEANAIR FILTER
1. Remove cover.
2. Carefully removecartridge.
3. Clean by gently tapping on a flat sur-
face. If very dirty, replacecartridge.
,I_I, C AUTION:
Petroleum
solvents,
such as
kerosene,
are not to be used to clean
car-
tridge.
They may cause
deterioration
of the
cartridge.
Do not oil cartridge.
Do not use
pressurized
air to clean
or dry cartridge.
4.
Install
cartridge,
then replace
cover.
Slot
Tab
Cartridge
Filter cover
Container
,
5.
6.
Wipe off any spilled
oil from lawn
mower
or side of engine.
Fill engine
with oil.
Slowly
pour oil
down
the oil fill spout
into the engine.
Wait one minute
to allow oil to settle.
Use guage
on oil fill cap/dipstick
for
checking
level.
Insert dipstick
into the
tube and rest the oil fill cap on the tube.
DO NOT thread
the cap into the tube
when
taking
reading.
Oil fill cap /
dipstick
Upper _
mark
Lower /
'_/
mark
7.
,
9.
Continue adding small amounts of
oil and rechecking
the dipstick until it
reads full. DO NOT overfill, or engine
will smoke on startup.
Always be sure to retighten oil fill cap/
dipstick before starting engine.
Reconnect
spark plug wire to plug.
AIR FILTER
Your engine
will not run properly
and may
be damaged
by using
a dirty air filter,
MUFFLER
Inspect
and replace
corroded
muffler
as it
could
create
a fire hazard
and/or
damage.
SPARK
PLUG
Replace
spark
plug at the beginning
of
each mowing
season
or after every
100
hours
of operation,
whichever
occurs
first.
Spark
plug type and gap setting
are shown
in the "PRODUCT
SPECIFIC-
ATIONS"
section
of this manual.
CLEANING
IMPORTANT:
For best performance,
keep mower
housing
free of built-grass
and trash.
Clean
the underside
of your
mower
after each
use.
,_CAUTION:
Disconnect
spark
plug wire
from spark
plug and place wire where
it
cannot
come
in contact
with spark
plug.
• Clean
the underside
of your
lawn
mower
by scraping
to remove
build-up
of grass
and trash.
• Clean
engine
often to keep trash from
accumulating.
A clogged
engine
runs
hotter and shortens
engine
life.
• Keep finished
surfaces
and wheels
free
of all gasoline,
oil, etc.
• We do not recommend
using
a garden
hose to clean
lawn mower
unless
the
electrical
system,
muffler,
air filter and
carburetor
are covered
to keep water
out.
Water
in engine
can result in short-
ened engine
life.
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents