Advertisement
Available languages
Available languages
The operation of any lawn
SAFETY
GLASSES
mower can result in foreign
objectsthrown into the eyes,
whichcanresultinsevereeye
damage.Alwayswearsafety
glasses or eye shieldswhile operating your
lawn moweror performingany adjustments
or repairs.Werecommenda standardsafety
glasses or wide vision safety mask worn
over spectacles.
HOW TO USE YOUR MOWER
ENGINE SPEED
The engine speed was set at the factory for
optimum performance.
It is not adjustable.
ENGINE ZONE CONTROL
,_k, C AUTION:
Federal regulations
require
an engine control to be installed on this
lawn mower in order to minimize the risk
of blade contact injury. Do not under
any circumstances
attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
• Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
DRIVE CONTROL
• Self-propelling
is controlled
by hold-
ing the operator presence control bar
down to the handle and pulling the drive
control lever rearward to the handle.
The farther toward the handle the lever
is pulled, the faster the unit will travel.
• Forward motion will stop when either
the operator presence control bar or
drive control lever are released. To stop
forward motion without stopping engine,
release the drive control lever only. Hold
operator presence control bar down
against handle to continue mowing
without self-propelling.
NOTE: If after releasing the drive control the
mower will not roll backwards, push the mow-
er forward slightly to disengage drive wheels.
• To keep drive control engaged when
turning corners, push down on the
handle to lift the front wheels off the
ground while turning lawn mower.
Operator
presence control bar
_rlve
control
levers
DRIVE CONTROL
ADJUSTMENT
Over time, the drive control system may
become "loose", resulting in decreased
speed.
There is a turnbuckle
on the
underside of the drive control housing to
increase tension on the drive cable.
Pro-
ceed as follows:
1. Turn unit off and disconnect
spark plug
wire from spark plug.
2. Turn nut on underside of drive control
to increase drive speed.
3. Operate mower to test drive speed.
Readjust as required.
4.
If condition fails to improve after the
above steps (forward speed remains
the same), your drive belt is worn and
should be replaced.
Adjustment
turnbuckle
TO ADJUST CUTTING
HEIGHT
Raise wheels for low cut and lower wheels
for high cut, adjust cutting height to suit
your requirements.
Medium position is
best for most lawns.
•
To change cutting height, squeeze ad-
juster lever toward wheel. Move wheel
up or down to suit your requirements.
Be
sure all wheels are in the same setting.
NOTE: Adjuster is properly positioned when
plate tab inserts into hole in lever. Also, 9-po-
sition adjusters (if so equipped) allow lever to
be positioned between the plate tabs.
ROTATE LEVER TOWARD
ENGINE TO LOWER MOWER
Plate tab
ROTATE LEVER AWAY FROM ENGINE
TO RAISE MOWER
-Lever
TO ENGAGE
DRIVE CONTROL
DRIVE CONTROL
DISENGAGED
11
Advertisement
