Husqvarna 917.384516 Owner's Manual page 17

,_ WARNING" To avoid serious injury,
before performing any service and
adjustments:
1. Releasecontrol bar and stop engine.
2. Make sure the blade and all moving
parts have completely stopped.
3. Disconnectspark plug wire from spark
plug and place wire where it cannot
come in contact with plug.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in
the Operation section of this manual.
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of your mower, is provided to
minimize the possibility that objects will
be thrown out of the rear of the mower
into the operator mowing position. If the
deflector becomes damaged, it should be
replaced.
TO ADJUST HANDLE
Mowing r-'q Mowing
position ,, position
i <"
Hairpin
___ _Handle
Mounting.,1 _ .... LLrl bracket
pin LOW POSITION HIGH POSITION
f_
/
I I I I
I
Lower
handle
The handle can be mounted in a high or
low position. The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle.
1. Remove upper handle and all wire
tie(s) securing cable(s) to lower handle.
2. Remove hairpin cotters from lower
handle bracket mounting pin.
3. Squeeze lower handle in to remove it
from mounting pins.
4. Turn lower handle over to raise or
lower handle.
5. Squeeze lower handle in and position
holes onto mounting pins on handle
bracket.
6. Reassemble upper handle and all
parts removed from lower handle.
SQUEEZE i
TO ADJUST
Lower handle""'-- I
'l:0u Mounting pin ---_
_... Handle tt_r /
bracket Hairpin cotter
ROTATE
17
ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that the engine is running too fast
or too slow, take your lawn mower to a
Husqvarna or other qualified service cen-
ter for repair and adjustment.
CARBURETOR
Your carburetor is not adjustable. If your
engine does not operate properly due
to suspected carburetor problems, take
your lawn mower to a Husqvarna or other
qualified service center for repair and/or
adjustment.
IMPORTANT: Never tamper with the
engine governor, which is factory set for
proper engine speed. Overspeeding
the engine above the factory high speed
setting can be dangerous. If you think
the engine-governed high speed needs
adjusting, contact a Husqvarna or other
qualified service center, which has proper
equipment and experience to make any
necessary adjustments.