Advertisement
Available languages
Available languages
ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that engine is running too fast or
too slow, take your mower to a Husqvama
or other qualified service center for repair
and adjustment.
CARBURETOR
Your carburetor is not adjustable.
If your
engine does not operate properly due
to suspected carburetor problems, take
your lawn mower to a Husqvarna
or other
qualified service center for repair and/or
adjustment.
IMPORTANT:
Never tamper with the
engine governor, which is factory set for
proper engine speed.
Overspeeding
the engine above the factory high speed
setting can be dangerous.
If you think
the engine-governed
high speed needs
adjusting, contact a Husqvarna
or other
qualified service center, which has proper
equipment
and experience
to make any
necessary adjustments.
Immediately
prepare your lawn mower for storage at the end of the season or if the unit
will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a
period of time, clean it thoroughly,
remove
all dirt, grease, leaves, etc. Store in a
clean, dry area.
1. Clean entire lawn mower (See
"CLEANING"
in the Maintenance
sec-
tion of this manual).
2. Lubricate as shown in the Maintenance
section of this manual.
3. Be sure that all nuts, bolts, screws, and
pins are securely fastened.
Inspect
moving parts for damage, breakage
and wear.
Replace if necessary.
4. Touch up all rusted or chipped paint
surfaces; sand lightly before painting.
HANDLE
You can fold your mower handle for storage.
1. Squeeze the bottom ends of the lower
handle toward each other until the
lower handle clears the handle bracket,
then move handle forward.
2. Loosen upper handle mounting bolts
enough to allow upper handle to be
folded back.
IMPORTANT:
When folding the handle
for storage or transportation,
be sure to
fold the handle as shown or you may dam-
age the control cables.
• When setting up your handle from the
storage position, the lower handle will
automatically
lock into mowing position.
SQUEEZE
TO FOLD
Operator
control bar
MOWING
POSITION
FOLD
J/J_/X
FORWARD
Upper
FOR
handle
STORAGE
Handle
knob
Lower handle
ENGINE
FUEL SYSTEM
IMPORTANT:
It is important to prevent
gum deposits from forming in essential
fuel system parts such as carburetor,
fuel
filter, fuel hose, or tank during storage.
Alcohol blended fuels (called gasohol or
using ethanol or methanol)
can attract
moisture which leads to separation and
formation of acids during storage. Acidic
gas can damage the fuel system of an
engine while in storage.
• Empty the fuel tank by starting the en-
gine and letting it run until the fuel lines
and carburetor
are empty.
• Never use engine or carburetor cleaner
products in the fuel tank or permanent
damage may occur.
• Use fresh fuel next season.
Advertisement
