Husqvarna 917.374470 Owner's Manual page 16

Crankshaft
Housing hole
adapter
Hardened
washer
Blade
bolt
Trailing edge
Lock-washer
6. Remove screw securing debris shield.
Note that the debris shield has a tab
which fits into a gap in the housing.
7. Use a wood block between blade and
mower housing to prevent blade from
turning when removing blade bolt.
NOTE: Protect your hands with gloves
and/or wrap blade with heavy cloth.
8. Remove blade bolt.
9. Remove blade, attaching hardware
(bolt, lock washer, hardened washer),
blade adapter and debris shield. Note
that the debris shield has a tab which
fits into the housing hole.
10. Remove drive belt from engine pulley;
discard old belt.
TO REPLACE DRIVE BELT
1. Place new drive belt on engine pulley.
2. Route the other end of the new drive
belt through hole in housing.
3. Return mower to upright position.
4. Install new drive belt into idler arm
assembly, then around the drive pulley.
Be sure belt is inside of belt keepers.
5. Reattach idler arm assembly with hex
nut previously removed.
6. Turn lawn mower on its side. Make
sure air filter and carburetor are up.
7. Reattach debris shield to housing with
tab of debris shield in housing hole.
8. Position blade on the blade adapter
aligning the two (2) holes in the blade
with the raised lugs on the adapter.
9. Be sure the trailing edge of blade (op-
posite sharp edge) is up toward the
engine as shown.
10. Install the blade bolt with the lock
washer and hardened washer into
blade adapter and crankshaft.
11. Use block of wood between blade and
lawn mower housing and tighten the
blade bolt, turning clockwise.
• The recommended tightening torque is
35-40 ft. Ibs.
IMPORTANT: Blade bolt is heat treated.
If bolt needs replacing, replace only with
approved bolt shown in the Repair Parts
section of this manual.
12. Return mower to upright position.
13. Reattach drive cable and return spring
to the idler arm assembly, then reat-
tach drive cable to anchor.
14. Reattach drive cover with screw(s)
previously removed.
15. Connect spark plug wire to spark plug.
TO ADJUST HANDLE
The handle on your lawn mower has three
(3) height positions - adjust to height that
suits you.
• Squeeze the bottom ends of lower
handle towards each other until the pin
in handle can be inserted into one of the
three height adjustment holes.
High Handle pin
Handle
bracket
ENGINE
Maintenance, repair, or replacement of
the emission control devices and systems,
which are being done at the customers ex-
pense, may be performed by any non-road
engine repair establishment or individual.
Warranty repairs must be performed by an
authorized engine manufacturer's service
outlet.
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that the engine is running too fast
or too slow, take your lawn mower to a
Husqvarna or other qualified service cen-
ter for repair and adjustment.
16