Hotpoint VVSR1040 Owner's Manual page 13

Troubleshootingtips
Save time and money! Review the charts on the following pages
fir.stand you may not need to call for service.
Possible Causes what ToDo
Washer won't operate Washer is unplugged ",'Make sure cord is plugged
securely into a working
outlet.
Water supply is turned off "_Turn both hot and cold
fa,ucets fully ono
Controls are not set
properly
:, Check controls and
make sure Cycle knob is
pulled out to ONposition.
Lid is open ._-' Close lid and pull Cyde
knob out to ONposidon,
Circuit breaker/fuse is '_ Check house circuit
tripped/blown breakers/i_ases. Replace
fuses or' reset breaker.
Washer should have
separate outlet,
Water temperature
is incorrect "
Control is not set properly '_ Check water' temperature
control and adjust,
Water supply is turned off %
or improperly connected
Turn botl3 hot and cold
faucets fully on and make
sure hoses are connected
to correct fa.ucets.
Water valve screens are
stopped up
Turn off the water source
and remove the water
connection hoses from
the upper back of the
washer, Use a brush or
toothpick to clean the
screens in the machine..
Reconnect the hoses and
turn the water back on,
House water heater is
not set properly
Make sine house water
heater is delivering water
at 120°F.-140°F.
(48°Co-60°C,).
'::iL:t
g!:;: _:=
!{}:?;:{{_
i!{):
13
t_!ii{;;i