Reversing The Door Swh]G - Hotpoint HTS18BBPPLCC Owner's Manual And Installation Instructions

mnstaliation mnstructions
REVERSING THE DOOR SWING
(CONT.)
[] TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
For models with a base grille, remo_e
it b) ,grasI)ing, it
about 6" fl'om each end and mllino its botton/edoe
t()wa rd _otl.
Using a Torx (_:' clrixet; moxe the bottom hinge bracket
and plastic washer fl'om the right side to the left side.
NOTE: If the washer is not on the hinge bracket,
check to see if it is stuck to the bottom of the dora:
-_ 1 PlasticWasher
*d /
.4"-
HingeBracket
For models with a base grille, before rei)lacim*_ the
base grille, remoxe the grille cap b) remoxing the
screw. Screw the cap to the opposite side.
Replace the base grille by inserting the tops of the
metal clips into the ox_fl vents, making sure one of the
plastic tabs on the back of the grille goes into each of
the oven vents. Then push the bottom of the grille
forward
tmfil it snaps into place.
[] TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remoxe the center hinge bracket
b} removim,_ the
three" T_rx_) screws.
NOTE: Keep these screws with the hinge bracket.
They are lon,* screws and will be used when installing
the hin,*e on the other side.
On some models you will need to remoxe the colo>
matched caps fl'om the screw heads befi)re you can
remoxe the screws. Use the edge of a thin fiat blade to
,_entlv, i)rv, the cai)s o# the ..... screw heads (A putt} knife
works well fiw this.) Coxer the blade with tape to
I)rexent scratching, the paint.
Remoxe the three Tmx" screws from the center lett
side of the cabinet. Screw them into the holes on
the right side.
Place the center hinge bracket oxer the holes at
the center lett side of the cabinet. Insert and
tighten the three hmg screws.
Replace the caps by, snaii ) )ing, them oxer the screws
with )ore" finger.
ScrewCap
e_
[] TRANSFER DOOR STOPS
On each do(m moxe the metal door stop ti'om the
right to the letL
Moxe any screws fl'om the left to the ri ,ht
Stop Door Sto
Left Side
RightSide
20