GE ASM24 Owner's Manual And Installation Instructions page 5

When the air conditioner is turned on, it will
automatically start in the setting last used.
GEAppliances.com
Power Outage Recovery Feature
In tile case of a power outage or interruption, tile
unit will
aut(nnatically re-start in
tile settings last
used alier tile power is restored. Tile
TIMERand
SLEEPfeatures will reset to tile original setting. 54m
may need to set a new time if desired.
COOLMode
Use the COOL mode with HIGH(3),MED (2)or
LOW(l) tim tot cooling. Use tile INCREASEA/
DECREASE • pads to
set
tile desired
temperature
between 64°F and 86°F in l °F increments.
A them_ostat is used to maintain tile room
temperature. Tile compressor will cycle on and off
to kee I) tile room at tile set level ot comfi)rt. Set tile
thermostat at a lower number and tile indoor air
will becolne coole_: Set tile theilnostat at a higher
number and tile indoor air will become wanne_:
NOTE: ff the air conditioner is off and is then turned on
while set to COOL, i t will take approximately3 m&utes
for the compressorto start and cooling to begin.
Cooling Descriptions
For Normal Cooling--Select the COOL mode
and HIGH (3) (>r MED (2) tim with a middle set
temperature.
ForMaximum
Coolim_---Select
tile COOL mode
and HIGH (3) tm_ with a lower set temperature.
For Quieter & Nighttime
Coolino---,Select tile
COOL
mode and
LOW (I)tim
with a middle set
temperature.
NOTE: If you switch from a COOL setting to OFFor to
a fan setting, wait at least 3 minutesbefore switching
back to a COOL setting.
FAN Mode
Use tile FAN at HIGH (3), MED (2) or LOW(l) t(> Since tim (rely settings do not pr(>vide cooling, a
provide air circulation and filtering without cooling, temperature setting will not be displayed.
Vent Control (on some models)
Tile vent control is located on tile inside ot tile
air lou\'ets in the lower right cornet;
X._]_en set at CLOSE, only the air inside the room
will be circulated and conditioned. _,_]/en set at
OPEN, some inside air is exhausted outside.
(/
if"
To open flTevent, push the lever to the right.
To close it, push it to the left.
Air Direction--Up and Down (on some models)
Fingertip pressure on tile horizontal louve_ a(!justs
tile air direction
up or down.
OR
Air Direction--Side-to-Side (onsomemodels)
On some models, tile side-t(_side air direction is
a(!justed by tile louver lex'e_ or by grasping and
moving tile inner vertical louvers.
OR