Installation Instructions - GE AER05 Owner's Manual And Installation Instructions

I
Installation
Instructions
Air Conditioner
I-_ Ouestions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or visit www.GEAppliances.ca
I
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
• IMPORTANT - Save these
instructions
forlocal inspector's use
• IMPORTANT - Observe all
governing
codes and ordinances
• Note to Installer- Be sure to leave these
instructions with the Consumer.
• Note to Consumer - Keep these instructions for
future reference.
• Skill level- Installation of this appliance requires
basic mechanical skills.
• Completion time - Approximately 1 hour
• We recommend that two people install this
product.
• Proper installation is the responsibility of the
installer.
Product failure due to improper installation is not
covered under the Warranty.
You MUST use all supplied ports and use proper
installation procedures as described in these
instructions when installing this air conditioner.
Q ELECTRICAL REQUIREMENTS
(_ ome models require a 115/120-volt AC,
60-Hz grounded outlet protected with a
15-amp time-delay fuse or circuit breaker.
The 3-prong grounding plug minimizes the
possibility of electric shock hazard. If the wall outlet
you plan to use is only o 2-prong outlet, it is your
responsibility to hove it replaced with o properly
grounded 3-prong wall outlet.
©
Some models require 230/208-volt AC,
protected with a time-delay fuse or circuit
breaker. These models should be installed
on their own single branch circuit for best
performance and to prevent overloading
house or apartment wiring circuits, which
could cause a possible fire hazard from
overheating wires.
CAUTION:
Do not, under any circumstances, cut or remove
the third (ground) prong from the power cord.
Do not change the plug on the power cord
of this air conditioner.
Aluminum house wiring may present special
problems--consult a qualified electrician.
TOOLS YOU WILL NEED
Phillips head screwdriver
Fiat-blade screwdriver
Pencil Ruler or tope measure
Level Scissors or knife
Power cord includes a current interrupter
device. A test and reset button is provided on the
plug case. The device should be tested on a periodic
basis by first pressing the TEST button and then the
RESETbutton while plugged into the outlet. If the
TEST button does not trip or
if the RESETbutton will not stay engaged, discontinue
use of the air conditioner and contact o qualified
service technician.